Pelco ECM100, EPM, EPP EPM ESPRIT POLE MOUNT, , ECM100 ESPRIT CORNER MOUNT

EPM ESPRIT POLE MOUNT
1. Thread wiring/cabling through the hole in the pole mount and attach the
mount to the pole with three stainless steel straps (supplied).
2. Attach the gasket to the end of the EWM.
3. Remove the knockouts from the conduit plate. Install the conduit fittings
(not supplied). If conduit is not used, install sealing glands (supplied) on
the conduit plate. Route the wiring/cabling through the conduit plate/
sealing glands and EWM wall mount. Secure the EWM and conduit
plate to the pole mount with the supplied hardware. Refer to the manual
supplied with the Esprit system to complete the installation.
ECM100 ESPRIT CORNER MOUNT
1. Use the ECM100 mount as a template and mark the fastener positions
onto the mounting surface. Prepare the surface. Route the wiring/
cabling through the ECM100. Attach the ECM100 to the mounting
surface with the appropriate hardware (not supplied).
2. Attach the gasket to the end of the EWM.
3. Remove the knockouts from the conduit plate. Install the conduit fittings
(not supplied). If conduit is not used, install sealing glands (supplied) on
the conduit plate. Route the wiring/cabling through the conduit plate/
sealing glands and EWM wall mount. Secure the mount to the ECM100
with the supplied hardware. Refer to the manual supplied with the
Esprit system to completed the installation.
NOTE: Refer to Tables A and B for wiring distances.
NOTE: Refer to Tables A and B for wiring distances.