Pelco EU3512-3X I, nstallation

C2428M-B (1/06) 5

nstallation

1. Drill holes in mounting surface using the mount as a template and attach the mount securely

with the recommended fasteners.

• If you are attaching the mount to a solid surface,

use the two top outside holes and the

bottom center hole. Secure with three 0.25-inch diameter fasteners (not supplied).

• If you are attaching the mount to a wall stud, use the top and bottom center fastener

holes. Secure with one 0.3125-inch fastener and one 0.25-inch fastener (not supplied).

2. If you install the mount outdoors, seal the fastener holes with an appropriate sealant to

prevent water damage. Apply the sealant between the mount and the mounting surface.

The following items are supplied to mount the enclosure:

2 1/4-20 x 0.500-inch hex head screws

2 Flat washers

2 Split washers

The following items are supplied to mount the camera:

2 1/4-20 x 0.375-inch Phillips screws

Perform the following steps to install the enclosure:

1. Unlatch and open the lid of the enclosure.

2. Remove the camera sled from the rail of the enclosure.

a. Loosen the screws that hold the camera sled in place.

b. Slide the sled forward so it can be lifted out over the screws.

c. Remove the sled.

d. Remove the parts bag tied to the sled. This includes the hex head screws, ﬂat washers,

split washers, glands, and nuts.

3. If you are wiring the enclosure with cable, remove the glands and nuts from the parts bag and

install them in the bottom of the enclosure. If you are wiring the enclosure with conduit, do

not install the glands.

4. Attach the base of the enclosure to the mount tilt table through the two threaded mounting

holes in the bottom of the enclosure. Use the 1/4-20 x 0.500-inch screws, the split washers,

and the ﬂat washers provided (in the parts bag). Completely tighten the screws to attach the

enclosure to the mount tilt table.

5. Loosen the cap nut located on the support bracket of the tilt table and adjust the tilt table to

the desired direction. Tighten the cap nut. Loosen the two screws on the tilt table and adjust it

for the desired angle. Tighten the screws.