Installation

PACKAGE CONTENTS

The following items are supplied:

1FT82041 or FR82041 module

1Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

1Wall clip with two 4-40 x 0.250-inch Phillips pan head screws with lock washers (for attachment of single module to wall)

1FT82041/FR82041 Fiber Transmitter and Receiver Installation manual

SETTING 10BASE-T/100BASE-TX PORT MODES OF OPERATION

NOTE: As a matter of convenience, it is recommended that you verify the modes of operation for each 10BASE-T/100-BASE-TX port and then change the mode settings—if necessary—before mounting the FT82041/FR82041 module into a rack or onto a wall.

The FT82041/FR82041 module provides various configuration options that allow you to select the desired modes of operation for each 10BASE-T/100BASE-TX port (ports 1-4). You can select the desired modes of operation by means of a TX Mode switch that is provided on the bottom of the module for each port (refer to Figure 4).

TX MODE SWITCHES - PORTS 1-4

TX Mode

L

L

Figure 4. TX Mode Switches for 10BASE-T/100BASE-TX Ports 1-4

C2623M (2/07)

11

Page 11
Image 11
Pelco FR82041 manual Installation, Package Contents