C1680M (1/06) 17
7. Connect power, fiber optic, and video cables to the transmitter by doing the following:
a. Insert the power cable through either of the two gland connectors on the enclosure,
route the cable underneath the transmitter toward the power connector on the
transmitter, and then connect the cable to the power connector.
b. Insert the fiber optic cable through either of the two gland connectors on the enclosure,
and then do the following:
WARNING: When routing the fiber optic cable, be careful not to bend the fiber
at a sharp angle. Doing so breaks the fiber.
(1) Route the cable above the transmitter and then along one side of the camera until
you can loop the cable underneath the lens; then route the cable back along the
other side of the camera toward the fiber optic connector on the transmitter (refer
to Figure7).
(2) Connect the cable to the fiber optic connector on the transmitter.
c. Using the coaxial cable supplied with the transmitter, connect the cable to the BNC
connector on the transmitter and on the camera.
NOTE: For additional information about connections to the transmitter, refer to the Connections
section.
8. Reconnect power to the camera.
9. If applicable, reconnect the heater wires of the enclosure.
10. Carefully slide the camera sled back into the enclosure.
11. Reinstall the screws in the rear plate.
12. Reconnect power to the enclosure.
Figure 7. Routing Fiber Optic Cable in EH2515 Enclosure
FIBER OPTIC CABLE