Pelco HD3515 Figure 1. Heater and Defroster Kit Installation, Figure 2. Wiring Diagram Figure 3. PC Board Component Locations

10. Do one of the following depending on the model number of the enclosure:

•EH3512 Series and EH3515 Series

Connect the heater and defroster wires to the PC board (refer to Figure 2). Be sure the

wires are not obstructing other accessories within the enclosure. If you are installing

HD3515-2 Heater Kit (24 VAC), refer to Table A, 24 VAC Wiring Distances.

•EH3515L Legacy® Series

Connect the front and rear heater wires to the HTRS connector (P5) on the circuit board

and the defroster wires to the FAN connector (P4) (refer to Figure 3). You are installing

a lower wattage defroster. You must connect the defroster to FAN (P4) on the PC board

to operate continuously. If you have a blower installed (which is also connected to P4),

splice the defroster wires to the fan wires. If you are installing HD3515-2 Heater Kit

(24 VAC), refer to Table A, 24 VAC Wiring Distances.

SCREW

LOCK WASHER

NYLON WASHER

PC BOARD

HEATER

DEFROSTER

HEATER

FRONT

HEATER

BRACKET

REAR

HEATER

BRACKET

EH3515 SERIES

AND EH3515L SERIES

ENCLOSURES ONLY

NYLON WASHER

Figure 1. Heater and Defroster Kit Installation

REAR HEATER

10 FRONT HEATER

DEFROSTER

INPUT, AC HIGH

INPUT, AC LOW (NEUTRAL)

GROUND

MODELS HD35 AND HD3515 SERIES

MODEL HD3515 SERIES ONLY