Pelco Manual C1985M-E (4/03) [ 3 ]
CAMERA LAYOUT
Figure 1. Camera Layout
INSTALLATION

Lens Mounting

The camera can use a fixed iris, manual iris, or auto iris. The camera is factory set for a CS-mount lens,
but is easily adjusted for a C-mount lens.
1. C-Mount Lens Only - Rotate the back focus adjustment fully counterclockwise before install-
ing the C-mount lens (refer to the section on
Back Focus Adjustment
).
2. Remove the cosmetic trim ring from the back of the camera (refer to Figure 1). Set the lens mode se-
lector switch on the side of the camera to AIV (auto iris video drive lens) or AID (auto iris DC drive
lens). Refer to the

Switch Settings

section. Switch setting is determined by the type of lens used.
3. Screw the lens onto the lens mount. Be careful to prevent dust from entering the space between the
lens and the CCD element. If necessary, use clean, compressed air to remove any foreign matter.
4. Thread the lens cable through the cosmetic trim ring.
5. Connect the auto iris lens to the four-pin connector located on the side of the camera. Pin connec-
tions for the iris drive connector are as follows:
PIN DC AUTO IRIS LENS VIDEO AUTO IRIS LENS
1Control coil negative (-) Lens positive supply
2Control coil positive (+) Not used
3Drive coil positive (+) Video drive signal
4Drive coil negative (-) Ground
Figure 2. Lens Connections
BACK FOCUS
ADJUSTMENT
RING
BNC VIDEO CONNECTOR
LENS CONNECTOR
DIP SWITCHES
LED
MOUNT ADAPTER
PHASE ADJUSTMENT
LEVEL ADJUSTMENT
POWER SUPPLY
BACK FOCUS
ADJUSTMENT
LOCKING
SCREW
COSMETIC TRIM
RING
3 4
12

NOTE:The cosmetic trim ring conceals the LED light for more discreet surveillance operations.

The trim ring also hides the power connectors and protects the DIP switches.