Pelco MC5700 D

Be sure to attach the lens mount cap when the lens is not mounted.

When using an auto-iris lens, use only a DC-driven type or a direct current drive coil with a

resistance value over 150 ohms.

When using an auto-iris lens, attach it as follows. For a manual lens, omit step 3. Refer to

Illustration E.

1. Unscrew the lens mount cap.

2. Screw in the lens. Make sure the C/CS adjustment ring is set properly.

3. Check the plug wiring on the lens cable against Illustration D and the pin-outs in the

“Plug Change on Auto-Iris Lens Cable” box. If you need to replace the existing plug,

follow the instructions in the box.

4. Adjust the backfocus. Follow the appropriate instructions in the “Lens/Camera Setup

and Backfocusing” Information Box. These instructions cover the setting of the CCD

IRIS switch (Illustration A in the owner’s manual). Also, if necessary, refer to the

“Camera/Lens Geometry-General Information” sheet.

D

1Cover (supplied)

Auto-iris lens cable

Rib (If the cable is thick

and the plug cover does

not seat properly, cut

away this rib.)

Lens plug (supplied)

Pin # DC-servo Lens

Pin 3: Drive (+)

Pin 1: Control (-)

Pin 2: Control (+)

Pin 4: Drive (-) (Ground)

1. Remove the old lens plug from the cable.

2. Remove the plug cover , add heat shrink tubing to the wires and solder the lens

cable wires to the pins thru on the plug supplied. Apply heat to the heat

shrink tubing. The pin assignments are as follows:

3. Put the cover on the plug.

5Auto Iris Plug