Pelco Manual C1995M-A (10/01) 23
CHANGING THE LANGUAGE
You can work in any of four languages: English, French, German, or Spanish.
There are two ways to set the language you want to work in: change the language selection
on the Main menu or reset the unit.
•Change on the Main Menu
1. Hold down the Quad button for more than three seconds to access the Main
menu.
2. Use the up arrow to position the cursor on the Language line.
3. Press the +/- button to cycle to the next language. The cursor will move to
highlight Exit.
4. If necessary, repeat steps 2 and 3 until you have the language you want.
5. When you have the desired language, arrow to one of the other menu options or
press the +/- button when Exit is highlighted.
•Reset the Unit
1. If the multiplexer is plugged in, unplug it.
2. Reset the multiplexer to factory defaults by holding down the VIEW button while
plugging in the multiplexer. Continue holding down the button until the Initializa-
tion menu appears.
Any programming you have already done will be lost. Also, any time you do a
reset, the unit defaults to the last language that was active.
3. A timer at the bottom of the screen begins a countdown. You must select the
language you want before the timer runs out (step 4).
4. Use the number buttons on the front of the multiplexer to highlight the software
version (language) you want: button number 1 = English, 2 = French, 3 = German,
4 = Spanish.
5. Let the timer run out. The language you chose is now active, as are the factory
defaults.
6. Program the multiplexer as desired.