42 Pelco Manual C1995M-A (10/01)
Table E. Operation Guide
(Continued)
Deactivates the alarm.
Deactivates the alarms.
Deactivates the alarm.
Deactivates the alarms.
Displays or removes the alarm log on
the main monitor.
Main and spot monitors respond to
programming instructions. If there are
multiple alarms, monitors will sequence
cameras. Monitors will return to previous
operation about 15 seconds after alarms
have timed out.
In alarms mode, any alarm will take
precedence and override the camera
being displayed.
Turns reduced flicker on and off.
1. For a single alarm, press the VIEW button
once.
2. For multiple alarms, press the VIEW
button once each time a camera with an
alarm sequences to the main monitor.
1. For a single alarm, press the VIEW button
twice.
2. For multiple alarms, press the VIEW
button twice each time a camera with an
alarm sequences to the spot monitor. This
clears the alarm log.
1. Press the VIEW button twice to display
the alarm log.
2. Do one of the following to close the log.
a. Press the view button twice to clear
the list and close the log.
b. Press any front panel button (except
SEQUENCE) once to close the log
without clearing the alarm list. (If
there are more than 18 alarms
logged, use the up/down arrows to
scroll through the list.)
Program alarms in the System Setup, Record
Setup, Camera, and Advanced System Setup
menus.
Double-press the 4-screen button.
Deactivate
alarm(s) for
camera display on
the main monitor.
Deactivate
alarm(s) for
camera display on
the spot monitor.
Open or close a
log of the last 72
alarms.
Display and record
alarms.
Toggle reduced
flicker.