4
CONTENTS

DESCRIPTION............................................................... 4

INSTALLATION.............................................................. 4

OPERATION.................................................................. 5

MAINTENANCE............................................................. 5

ILLUSTRATIONS........................................................... 5

UNPACKING
Unpack carefully. This is electronic equipment and should be handled
with care.
The shipping carton is the safest container in which the unit may be trans-
ported. Save it for possible future use.
DESCRIPTION
The PMC09A Series are 23-cm (9-inch) color video monitors for special-
ized surveillance and industrial CCTV applications. These color monitors
provide excellent picture quality and convenient control of functions. They
are ideal for time lapse and event alarm VCR systems, or color video
multiplexers.
INSTALLATION
Location — The monitor should be located in a position such that the
flow of air around the unit is not restricted. Avoid heat vents or other heat
sources. Component life is greatly enhanced with moderate tempera-
tures.
Power
Model Rated Voltage Nominal Color
No.1Voltage Range Power 2System
PMC09A 120 VAC, 60 Hz 108 to 132 0.63 A NTSC
PMC09A-X 230 VAC.50Hz 198 to 264 0.31 A CCIR PAL
1. These units may be supplied with grounded power cords; ground-
ing should not be defeated.
2. At rated voltage.
Video Cabling — To assure good picture quality, use 75 ohm coaxial
cable and be sure the unit is terminated correctly. Cable attenuation should
also be considered on long cable runs and adequate video signal levels
provided.
When the monitor is located at the end of the cable run, use the VIDEO IN
connector on the rear of the chassis and set the termination switch to the
“75 Ω” position. Use the VIDEO OUT connector when the video cable is
“looped through” the monitor to other video equipment and set the termi-
nation switch on to the last piece of equipment on the line to the “75 Ω”
position.