Pelco pmc14f 4.0 OPERATION

4.0 OPERATION

Refer to Figure 5 for front panel controls.

1. Press the POWER switch to turn the monitor on. The power LED lamp above

the switch will illuminate when the power is applied.

2. Adjust the VOLUME control for the desired audio level. Turn the control clock-

wise to increase and counterclockwise to decrease.

3. Adjust the CONT. control for the desired overall contrast. Proper adjustment

will allow maximum gradations between the darkest and lightest picture con-

trast. Turn the control clockwise to increase and counterclockwise to decrease.

4. Adjust the BRIGHT control for the desired overall display brightness. This con-

trol is also useful to compensate for differences in surrounding area lighting.

Turn the control clockwise to increase and counterclockwise to decrease.

5. Adjust the COLOR control to set the color saturation level. Turn the control

clockwise to increase and counterclockwise to decrease.

6. Adjust the SHARP control to obtain the clearest picture.

7. Adjust the TINT control for the proper color phase or flesh tones. When turned

clockwise, the skin tone becomes greenish. When turned counterclockwise, skin

tone becomes reddish.

Passive looping is accomplished when two or three monitors are connected in se-

ries (see Figure 3) and a looping signal is sent through the IN and OUT connectors

of one monitor to the next in the series. Unless you want to view the monitor(s),

none of them need to be turned on for passive looping to function.

VOLUME POWERCONT.BRIGHTCOLORSHARPTINT

POWER

LED LAMP