Cycle Selector Buttons | Option Selector | Buttons |
Before starting your dishwasher
1.Spin the Upper Spray Arm to make sure nothing will stop it from turning freely.
2.Close and latch the door.
3.Run hot water at sink nearest dish- washer until it is hot. Turn it off.
Starting your dishwasher
HEAVY WASH Cycle
1. Make sure Cycle Control Knob points to dot marked HEAVY WASH.
2. Push HEAVY WASH button.
3. Push button for option desired.
4. Without turning it, pull out the Cycle Control Knob to start the cycle.
ENERGY SAVING WASH Cycle...
1.Turn Cycle Control Knob until it stops at dot marked ENERGY SAVING WASH.
2.Select option.
3.Withoutturning it, pull the Cycle Control Knob out to start the Cycle.
Changing a setting
You can change a setting
1.Unlatch the door to stop the cycle, but don’t open it until the spray arms stop spinning.
RINSE & HOLD Cycle...
1.Push the RINSE HOLD Cycle Button.
2.Unlatch door and open slightly.
3.Pull Cycle Control Knob out.
4.Turn Control Knob clockwise to dot marked
RINSE & HOLD.
5.Close and latch the door to start the cycle.
2.With the Cycle Control Knob pulled out, turn clockwise to the cycle you want.
3.Be sure the detergent dispensers are filled properly for the new cycle.
4.Latch the door to start the cycle.