4.0 INSTALLATION
1.Remove rubber feet on bottom of monitor.
2.Install monitor through rear of rack and align holes in bottom of monitor with mounting holes in rack.
3.Use hardware from rubber feet to mount monitor to rack.
4.Install rack and monitor as an assembly into con- sole and make any required electrical connections.
5.Hold into place, aligning mounting holes of the RMA429 with mounting holes in console, and in- sert and tighten required fasteners (not supplied). If only a single monitor is used, install cover plate up against window frame and then insert fasteners and tighten.
2 | Pelco Manual C979M (1/93) |