C1492M-I (8/05) 7
2. Set the J1 jumper on the TXB-AD to the proper termination setting. The TXB-AD is shipped from the factory with the J1 jumper in the terminated position. To unterminate the unit remove the cover from the J1 jumper and then place the cover over one pin for storage. Refer to Figure 2 and Figure 3.
Figure 2.
TXB-AD Translator Board Layout, Front and Back
Figure 3.
Receiver Location
3. Set DIP switches on the TXB-AD. Refer to Figure 2 and Table A.

16-PIN CONNECTOR

J1 JUMPER

BACK DIP

SWITCH

FRONT

J1 TERMINATED

J1 UNTERMINATED

AMERICAN DYNAMICS

CONTROLLER

AMERICAN DYNAMICS

CONTROLLER

PTZ

PTZPTZPTZPTZPTZ

PTZ PTZ

PTZPTZPTZPTZ

LINE
1
LINE
1
LINE
2
LINE
3
LINE
4
LINE
5
LINE
2
LINE
3
LINE
4
LINE
5
RECEIVERS
EXAMPLE OF STAR CONFIGURATION WITH DAISY CHAIN
RECEIVERS
EXAMPLE OF DAISY-CHAIN CONFIGURATION
= TERMINATED = UNTERMINATED
LINES 1-5 MUST NOT TOTAL MORE THAN 4,000 FT (1,219 M)