GENERAL CARE AND
MAINTENANCE
1.Clean o-rings with a soft clean cloth to insure that sealing area is free of dirt that could destroy the o-ring seal.
2.Apply a light coat of clear silicone grease on the o-rings occasionally if turning action becomes too difficult.
3.Remove the tail cap and wipe the rear threads of the 2360 flashlight body and inside of the tail cap with a soft clean cloth occasionally to avoid intermittent flashlight operation.
CAUTION
To prevent the 2360 flashlight coming on accidentally when the flashlight is stored, remove the batteries. If the 2360 flashlight is turned on while it is in a container, the flashlight can overheat and damage the flashlight or the material of the surrounding area.
SPECIFICATIONS
BULB:LED
BATTERY: (2) Two AA alkaline or other equivalent alkaline batteries
O-RING MAINTENANCE
Check closely for cuts, scratches, or otherwise damaged o-ring or mating lens lip surface. Remove any dirt or foreign matter from o-ring sealing surfaces. Keep threads, o-ring groove and inside lip of lens lubricated with silicone grease. See Warranty information for replacement of o-ring.
Battery Safety Bulletin Alkaline Batteries
1.Hazardous location safety approvals for explosive environments are only valid for the specified cell type manufacturer and, where applicable, brand names that are displayed on the flashlight and/or instructions sheets that are supplied with the light.
2.The use of other battery technologies may reduce the performance of the the flashlight. Always read the battery manufacturers recommendations for the appropriate use of the battery technology/ brand prior to using them in the flashlight.
3.When replacing the batteries:
a.Replace all the batteries at the same time.
b.Do not mix battery brands and old and new batteries.
c.Always insert batteries correctly with regard to polarity
(+ and -) marked on the battery and equipment.
2363.313.000.indd 1
4.Do not change batteries in a hazardous location.
5.Remove batteries from equipment if it is not to be used for an extended period of time.
PELICAN LEGENDARY FULL LIFETIME GUARANTEE OF EXCELLENCE
Pelican Products, Inc. guarantees its lights for a lifetime against breakage or defects in workmanship. This guar- antee does not cover the lamp or batteries (rechargeable or alkaline).
Pelican will either repair or replace any defective product, at our sole option. THE REMEDIES HEREBY PROVID-
ED SHALL BE THE EXCLUSIVE AND SOLE REMEDY OF THE PURCHASER. TO THE EXTENT PERMITTED BY LAW, IN NO EVENT SHALL PELICAN BE LIABLE FOR ANY INDIRECT, PUNITIVE, INCIDENTAL OR CON- SEQUENTIAL DAMAGES, OR SPECIAL DAMAGES, REGARDLESS OF WHETHER A CLAIM FOR SUCH DAMAGES IS BASED ON WARRANTY, CONTRACT, NEGLIGENCE OR OTHERWISE. In no event shall Pelican’s liability to the purchaser for damages hereunder exceed the purchase price of the product in respect of which damages are claimed.
To make a warranty claim, the purchaser must contact Pelican Products, Inc. at 23215 Early Avenue, Torrance, CA 90505 or sales@pelican.com. Any warranty claims shall be made by the purchaser as soon as practicable. The purchaser must obtain a return authorization number from Pelican Customer Service prior to returning any product.
In the event that Pelican determines that any returned product is not defective, within the terms of this warranty, the purchaser shall pay Pelican all costs of handling, transportation and repairs at Pelican’s prevailing rates.
All warranty claims of any nature are barred if the flashlight has been altered, damaged or in any way physically changed, or subjected to abuse, misuse, negligence or accident.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limita- tion or exclusion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
Lifetime Guarantee does not cover Roto Molded or AALG products.
Refer to www.pelican.com/warranty for full details.
LA LÉGENDAIRE GARANTIE D’EXCELLENCE À VIE DE PELICAN.
Pelican Products, Inc., garantit ses éclairages pour toute la durée de leur vie utile contre la casse et les défauts de fabrication. Cette garantie ne couvre pas les ampoules ni les batteries (alcalines ou rechargeables).
Pelican réparera ou remplacera tout produit défectueux, à sa seule discrétion. LES RECOURS MENTIONNÉS ICI CONSTITUENT LES SEULS RECOURS DE L’ACHETEUR.
DANS LA MESURE PERMISE PAR LA LOI,EN AUCUN CAS PELICAN NE SERA TENU RESPONSABLE D’AUCUN DOMMAGE IMMATÉRIEL, PUNITIF, ACCESSOIRE OU INDIRECT NI D’AUCUN DOMMAGE PARTICULIER, QU’UNE RÉCLAMATION POUR DE TELS DOMMAGES SE BASE OU NON SUR UNE GARANTIE, UN CONTRAT, UNE NÉGLIGENCE OU AUTRE. En aucun cas la responsabilité de Pelican envers l’acheteur en cas de dommages ne sera supérieure au prix d’achat du produit pour lequel des dommages et intérêts sont réclamés.
Pour déposer une demande de prise en charge sous garantie, l’acheteur doit contacter Pelican Products, Inc., à l’adresse suivante
:23215 Early Avenue, Torrance, CA 90505, États-Unis, ou envoyer un courrier électronique à l’adresse suivante : sales@pelican.com.
Toute demande de prise en charge sous garantie sera déposée par l’acheteur dès que possible. Avant de retourner tout produit, l’acheteur doit obtenir un numéro d’autorisation de retour du Service Client de Pelican. Au cas où Pelican considérerait qu’un produit retourné n’est pas défectueux, selon les conditions de la présente garantie, l’acheteur remboursera Pelican de tous les frais de manipu- lation, transport et réparation aux taux en vigueur de Pelican.
Toute demande de prise en charge sous garantie, de quelque nature que ce soit, sera refusée si la torche a été modifiée, endom- magée ou physiquement changée d’une façon ou d’une autre ou encore sujette à un traitement abusif, une mauvaise utilisation, une négligence ou un accident.
Certains États n’autorisent pas l’exclusion ou la limitation des dom- mages accessoires ou indirects, de telle sorte que la limitation ou l’exclusion mentionnée ci-dessus peut ne pas s’appliquer dans votre cas.
La présente garantie vous donne des droits légaux spécifiques et vous pouvez bénéficier d’autres droits, variables d’un État à l’autre.
La garantie à vie ne couvre pas les produits rotomoulés ou AALG. Pour obtenir des informations complètes, visitez le site www.pelican. com/warranty.
PELICANTM PRODUCTS
23215 Early Avenue • Torrance, California 90505 USA Tel 310.326.4700 • FAX 310.326.3311 • www.pelican.com
PELICANTM CANADA
10221-184 St. • Edmonton, Alberta T5S 2J4
Tel 780.481.6076 • FAX 780.481.9586
PELITM PRODUCTS, S.L.U.
c/ Provença, 388, Planta 7 • 08025 • Barcelona, Spain
Tel: +34 934 674 999 • Fax: +34 934 877 393
2363-313-000 5-0883 Rev A
© 2011 Pelican Products MR/11
All trademarks are registered and/or unregistered trademarks of Pelican Products, Inc., its subsidiaries and/or affiliates.
Cat. #2360 PELICANTM
2360
LED
INSTRUCTION MANUAL INTRODUCTION
This compact flashlight produces an ultra bright light beam by using a LED powered by (2) two
AA1.5V alkaline batteries. The 2360 flashlight is designed for easy use with one hand operation and has a dual-switch mode for constant-on and momentary-on. The 2360 flashlight body is made by high precision CNC machines from aircraft- grade aluminum alloy for the most durable con- struction. The 2360 flashlight is water resistant.
TO INSERT BATTERIES
1.Remove the tail cap by turning counter-clockwise.
2.Install (2) two AA alkaline batteries with + terminal facing to the head assembly.
3.Replace the tail cap onto the flashlight by turning clockwise until sealed.
OPERATION
1.MOMENTARY -
Gently depress the tail button for momentary
operation.
Press once for high, press again within a second to change from high to low
2.CONSTANT ON - Single Click for High
Triple Click (within a second) for low
3.LIGHT-OFF -
Press the tail button to turn OFF.
TO CHANGE BATTERIES
1.Remove the tail cap by turning counter-clock- wise until it comes off the rear
of the 2360 flashlight.
2.Remove the (2) two used batteries from the 2360 flashlight.
3.Install the (2) two new AA alkaline batteries with + terminal facing to the head assembly.
4.Replace the tail cap by turning clockwise until sealed.
11/9/11 4:02 PM
