Pella 801P0101 INSTALLING ROTO COVER AND CRANK, LOCK LEVER REMOVAL AND INSERTION

INSTALLING ROTO COVER AND CRANK

Note: Finish the interior of the window and allow

the window to dry before proceeding with these

instructions. (To open the window for ﬁnishing,

partially insert the lock handle into the jamb,

unlock the unit, temporarily attach the crank

handle and turn to open.)

A. Place the cover over the operator stud and snap

into place.

B. Apply pressure to the pocket end of the cover and

snap into place.

#5SEAMEDIUMSIZEmATBLADESCREWDRIVERTOLOOSEN

the set screw in the crank handle.

D. Slide the crank handle onto the stud. Unlock, open

window, then close and lock window.

E. Fold the crank handle down and check alignment

of knob with the pocket.

Note: You may need to adjust the crank position

on the stud until the correct alignment is

achieved.

F. Open the crank and tighten the set screw.

'!FTERTHElNALINSTALLATIONFOLDTHECRANKOVERAND

snap the knob into the pocket.

Note: Even with the window open the crank can

be folded to avoid interfering with the window

treatments.

Crank Handle

Operator Stud

Set Screw

Pocket End

Operator Stud

Knob E

Pocket

LOCK LEVER REMOVAL AND INSERTION

Note: You may want to remove the lock lever prior to ﬁnishing the window,

or if it needs to be replaced with a lock lever in a different ﬁnish.

A. Unlock and open the window.

B. Place the lock lever in the locked position.

#&ROMTHEEXTERIOROFTHEWINDOWINSERTASMALLmAT

blade screwdriver into the slot behind the lock lever.

D. Pry the cam away from the side of the window by

rotating the screwdriver a quarter turn.

Note: This will release the hook in the lever from

the cam hook.

E. Remove the lock lever by pulling it toward the

interior of the building.

F. To install a lock lever, hold it in the lock position

and insert it, from the interior, into the slot until it

snaps into the cam.

Interior

Exterior

Interior

Exterior