5REINSTALL THE SLIDING PANEL
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL SAFELY.
A.Insert door panel. From the exterior of the building, tilt the top of the panel toward the door frame and insert the top of the door panel into the top track. Move the bottom of the panel toward the door frame until it is vertical. Gently set the panel down into the bottom track.
Architect Series: Adjust the panel clip and tighten the panel clip screw.
ProLine only: Install bumpers and the panel retainer. Follow the instructions included in the hardware box.
Note: Be careful not to pinch your fingers between the two panels. DO NOT close the sliding panel until you have installed the hardware. The door may lock when closed.
x |
B.Install the handles and panel retainer. Follow the instructions included in the hardware box. If the panel is not square to the door frame, adjust the bottom rollers by removing the adjusting hole cover and inserting an 8" long #2 Phillips screwdriver into the hole. Turn clockwise to raise the panel and
C.Install screen. Instructions for installing the screen are found in the screen door package.
6INTERIOR SEAL
Caution: Ensure use of low pressure polyurethane window and door installation foams and strictly follow the foam manufacturer’s recommendations for application. Use of high pressure foams or improper application of the foam may cause the door to bow and hinder operation. DO NOT use fiberglass insulation.
A. Apply insulating foam. From the interior, insert the nozzle of the applicator approximately 1" deep into the space between the door and the rough opening and apply a 1" deep bead of foam. This will allow room for expansion of the foam and will minimize squeeze out. If using foam other than Great Stuff ™ Window and Door Insulating Foam Sealant by the Dow Chemical Company, allow the foam to cure completely (usually 8 to 24 hours) before proceeding to the next step.
Note: DO NOT completely fill the space from the back of the fin to the interior face of the opening.
6A
B. Check the door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level, square and that the sides are not bowed. If adjustments are required, remove the foam with a serrated knife. Adjust the shims, and reapply the insulating foam sealant.
SEALING THE DOOR TO THE | 4065) | &45&3/ | |
7 EXTERIOR WALL CLADDING | |||
| |||
Note: When applying the casing bead for stucco, leave 1/2" space |
| *5) | |
456$$0 | |||
between the head of the door and the casing bead, and 3/8" space | |||
|
| ||
between the door jambs and the casing bead for backer rod and |
| #BDLFS3PEBOE | |
sealant. Refer to the illustration (Southwestern Wall With Stucco). |
| 4FBMBOUUZQJDBM | |
Note: The sealant details shown are standard recommendations |
| $MFBSBODF | |
| "DDFTTPSZ | ||
from the sealant industry. Contact your sealant supplier for | *OTVMBUJOH | ||
(SPPWF | |||
recommendations and instructions for this and any other application. | 'PBN |
| |
|
| ||
