C.Begin the sill sealant bead 1/2" from one jamb, running it across the sill and stopping
1/2" from the opposite jamb. This 1/2" sealant gap on each side of the sill allows for incidental water drainage.
D.Shape, tool, and clean excess sealant. When finished, the sealant should be the shape of an hourglass.
Note: This method creates a more flexible sealant line capable of expanding and contracting.
EXTERIOR FINISH OF EXISTING FRAME
Any exposed wood and flashing tape on the exterior needs to be covered/protected. There are many ways to accomplish this, and each case can be unique.
A few possibilities include:
a) Covering the existing trim with aluminum coil wrap/ frame expander.
b)Sanding, priming and painting to match existing trim.
c)Covering the exposed wood with a high quality exterior grade sealant.
Note: The contractor/installer will determine how to finish the exterior.
|
| EXTERIOR OF WINDOW | ||
|
| WITH FRAME EXPANDER | ||
INSTALLING ROTO COVER AND CRANK |
|
|
|
|
CASEMENT A. Place the cover over the operator stud and snap |
|
|
|
|
AWNING/ | Pocket End | B |
| |
into place. |
| |||
|
|
|
| |
B. Apply pressure to the pocket end of the cover and |
|
|
|
|
snap into place. |
|
|
|
|
C. Use a medium size | A | Operator Stud | ||
loosen the set screw in the crank handle. |
|
|
|
|
D. Slide the crank handle onto the stud. Unlock, | Crank Handle | D |
| |
open window, then close and lock window. |
|
|
| |
Operator Stud |
|
| ||
|
|
| ||
E. Fold the crank handle down and check |
|
|
|
|
alignment of knob with the pocket. |
|
|
|
|
Note: You may need to adjust the crank |
|
|
|
|
position on the stud until the correct alignment |
| Set Screw |
| |
is achieved. |
| C | ||
|
|
| ||
F. Open the crank and tighten the set screw. | Knob |
|
| E |
|
|
|
|
G. After the final installation, fold the crank over and snap the knob into the pocket.
Note: Even with the window open the crank |
|
can be folded to avoid interfering with the |
|
window treatments. | |
|