OPERATING INSTRUCTIONS
ADDITIONAL FEATURES
IMPORTANT!
Your heater is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your outlet. DO NOT defeat the safety purpose of the polarized plug.
Carry
Handle (behind
B 
C 
A
This heater has additional features:
Internal Safety Fuse - acts as back up protection to the Thermal
Convenient Carry Handle – allows for easy transport from room to room.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
Ensure that your circuit breaker or fuse is working properly.
Be sure the heater is plugged in and that the electrical outlet is working properly.
Check for any obstruction. If you find any obstruction, turn the heater “ OFF” . Unplug the heater and wait a few minutes for it to cool down. Carefully remove the obstruction. Plug the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD
Control Panel Functions
A Power and Setting Control B Power Indicator Light
CCaution Indicator Light
Place the heater on a firm level surface free from obstructions, and at least 3 ft. away from any wall and any other objects such as furniture, curtains, plants or combustible material.
With the Power and Setting Control “ A” in the ” MIN” position, the Power Indicator Light
“B” not illuminated, and the heater in “OFF”status, plug the heater into a grounded 120V outlet.
Turn the heater ”ON” by turning the Power and Setting Control “ A” clockwise to your desired setting .The Power Indicator Light “ B” will illuminate. The power setting operates at 1500 Watts. Turn the heater ”OFF” by turning the Power Control to “MIN”.
The power and Setting Control “ A” can be use as a thermostat. Turn the “ A” to your desired setting from “ MIN” to “ MAX” . Turning the “ A” clockwise will increase the “set” temperature; turning the thermostat counterclockwise will decrease the “set” temperature.
When the room reaches a comfortable temperature, slowly turn the “ A”
CAUTION: This heater includes an Overheat Protection System that shuts the unit off if it overheats due to abnormal conditions. At this time, the “C” Caution Indicator Light gets on. If this occurs turn the heater “OFF”, unplug it, and inspect and remove any objects on or adjacent to the heater. Allow it to cool for a few minutes, plug it back in, and resume normal operation.
CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING TO THE SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for
Turn the heater “ OFF” , unplug it and wait for the heater to cool down.
Use a dry cloth to clean only external surfaces of the heater.
Do not use any cleaning agents or detergents.
Never immerse the heater in water.
Pack the heater in the original carton and store it in a cool and dry place.
SPECIFICATIONS
Model No.:
Voltage: 120V, 60Hz
Current: Maximum continuous draw: 12.5 Amps.
Output: 5200 BTUs
Power: LOW = 900 Watts, HIGH = 1500 Watts
Tolerances on all specifications: Approximately +5%,
