Installation
The Deck Jet body is designed to be connected to a 3/4” Sch40 PVC pipe (Figure 2). After the pipe is pressure tested, solvent weld the Deck Jet body to the 3/4” supply pipe. NOTE: Use PVC/ABS glue only. Anchor the Deck Jet body, with the Deck Jet cover attached, so the cover is level with the finished deck surface.
Swivel base
Attach Teflon tape to the swivel base and screw the swivel base into the Deck Jet body
| ¾” Sch40 pipe slip | |
| connection | |
|
|
|
| Solvent weld ¾” supply | |
| pipe to ¾” Sch40 pipe |
|
| slip connection |
|
| ¾” supply pipe | |
Figure 2 |
| Figure 3 |
Swivel nozzle
Byhand,pushtheswivel nozzle on to the swivel base until it snaps into place
Swivel base
Once the deck is finished, flush any debris from the supply pipe using the pump and filter system that supplies the Deck Jet. Apply Teflon® tape to the threads of the swivel base. Remove any debris from the cup and screw the swivel base into the Deck Jet body (Figure 2).
By hand, push the swivel nozzle until it snaps onto the swivel base (Figure 3).
Operation
Start the pump and adjust the appropriate valves as necessary to create the desired water effect.
If the stream of water is disrupted, remove the Deck Jet Cover, Jet and Jet Swivel Base. Check to see if there is any debris blocking the Jet.
To winterize, remove the Jet and Jet Swivel Base. Blow the lines clear with air, and install a 1/2” threaded plug.
3
