P10
1 BEFORE USING THE INSTRUMENT
Remaining Battery Charge
When the instrument's power is turned on, a battery mark "" will be
displayed on the right of the display screen. This mark can be used to check the
charge status of the battery.
Low battery: Please change. Replace with the spare battery or charge.
Charging the battery
Th e battery BP02 is not charged at our factory shipment so charge it.
For BP02 ch arge, use the special BC03 charger.
[Connection of code ]
Insert the output plug of the power supply code in Jack of the AC adaptor.
Insert the output plug of the AC adaptor in Jack of the charger.
Insert the power supply plug of the power supply code in the outlet of domestic use
AC power supply (100V,50Hz-60Hz).
[Installation of battery ]
Draw the battery to the lock lever side and put it on the battery pocket. The battery is
firmly installed on the battery pocket.
Press down the battery and then slide it to the opposite direction of the lock lever.
The lock lever goes up, and the battery is fixed.
Under such a condition, if Connection of the code" is done, the charge with the