Peripheral Electronics MP3 Player Accessories instruction manual Programming the Pxdp

1.6 Programming the PXDP

Now that you have identified the correct harness and dip-switch configuration using the application guide, it is now time to program the interface.

To program the interface, set the dip-switches located on the side of the interface (see Fig.1 below) to the congfiguration listed for your vehicle in the online applica- tion guide:

http://www.peripheralelectronics.com/apps

Switches are in their default setting of “off” in the up position and are turned “on” when switched down. Refer to the chart on the bottom of this page.

This programs the PXDP to the vehicle it is being installed in. The dip-switches MUST be set before the interface is plugged into the vehicle. Otherwise the PXDP will not work correctly.

Fig.1 Side view of Interface with dip switches

1	2	3	4	5	6	7	8
DIP						ON

See for config settings:

http://www.peripheralelectronics.com/apps

Dip Switch Configuration Chart

	1	2	3	4	5	6	7	8
Config. #1	ON	off	off	ON	off	off	off	ON
Config. #2	ON	off	off	off	off	off	off	ON
Config. #3	off	off	off	ON	off	off	off	ON
Config. #4	off	ON	off	off	off	off	off	ON
Config. #5	ON	ON	off	off	off	off	off	ON
Config. #6	off	off	ON	off	off	off	off	ON
Config. #7	ON	off	ON	off	off	off	off	ON
Config. #8	off	ON	ON	off	off	off	off	ON
Config. #9	ON	ON	off	ON	off	off	off	ON

3