DIRECT STATION PRESET BUTTONS 1 –

9 (White numbered buttons)

The Channel Preset buttons are labelled 1 to 9.These buttons allow direct selection of preprogrammed station channel pre-sets and are also used in the initial station pre-setting procedure (see MEMORY section in manual). For selection of channels 1 through 10 simply point the remote towards the tuner front panel and depress the channel number required. For channels 10 through 30 depress the first digit and second digit within 5 seconds.

FRONT PANEL DISPLAY & CONTROLS

Whilst the ETR is primarily designed for operation utilising the supplied remote controller, there are however some basic and seldom used controls on the front panel - the following is a list of the front panel controls provided and description of their functions: (Also Refer REMOTE CONTROLLER sections above).

- REMOTE SENSOR WINDOW

This window is located to the left beside the buttons of the front panel indicator panel and houses the remote sensor. Ensure this area is not covered in any way as this may inhibit the remote controls performance.

- BAND BUTTON

The Band button is located both on the front panel and remote controller. Depressing this control alternately causes the ETR to switch between AM and FM bands

- MONO BUTTON

The Mono control button is not replicated on the remote control. It is designed to enable the ETR to receive weak signal strength stations. Operation of this mode will defeat

the muting circuitry and produce a mono output signal. (The muting circuitry employed in the ETR is designed to remove unwanted hiss and spurious noise ).

- MEMORY BUTTON

The Memory control button is not replicated on the remote control however this control in conjunction with the remote controller enables pre-setting of up to 30 AM or FM stations, directly accessible from the remote control. The instructions for setting up pre-set stations are as follows -

a)Select the band AM or FM you wish to select a radio station from.

b)Select a station you wish to pre-set using the tuning buttons on the remote control or front panel in either manual or auto tuning modes.

c)Decide which channel (pre-set) number to assign to the station (We will use channel 11 for this example).

d)With the remote in one hand, push the Memory button on the ETR front panel at which time the Memory light will illuminate.

e)Point the remote at the ETR front panel and depress the 1 button then release it. Then depress the number 1 button again within 5 seconds and release it at which time the display will indicate 'CH11' and the 'MEMORY' light will extinguish - CH11 is now pre-set.

f)To pre-set further channels repeat as above.

-TUNING BUTTONS ∧ (Up) ∨ (Down) Tuning control buttons are located on both the remote control and front panel. For a

description of their operation refer to TUNING in the REMOTE CONTROLLER section above (see also AUTO TUNING above).

- AUTO BUTTON

See Auto Tuning section above.

- DIGITAL DISPLAY

The fluorescent display is located on the front panel of the ETR and indicates the following:

Frequency band (AM or FM)

RF Level (Signal strength)

Frequency

Auto (If auto tune function is selected) Memory ( If memory function is selected) Stereo (if receiving a stereo broadcast) Tuned (if tuned to a station)

Ch−−− ( # of a memorised station pre-set )

REAR PANEL CONNECTIONS / LABELS

The following user connections and labels are situated on the rear panel of the ETR - Please ensure all warnings are read, noted and adhered to.

- SERIAL NUMBER LABEL

All Perreaux units are allocated a unique serial number which are recorded at the factory against build details. If you should require information about your unit, providing the serial number will help achieve a prompt reply. Keep a copy of all your serial numbers in a safe place. The ability to identify and prove ownership can be very useful.

- MAINS/LINE VOLTAGE LABEL

The voltage label indicates the mains/line voltage the unit will accept. Always check this setting when first installing your ETR. A variance of +/- 5% above or below that

4