Adjustment
13.05.13 Hook lubrication
Requirement
1.The centrifugal disk 1 must be positioned 1.5 mm in front of the oil ring 3.
2.When the machine is running at full speed, after approx. 10 seconds a mark should be made by a fine stripe of oil on the strip of paper placed over the needle plate cutout.
3
2
1
Fig. 13 - 14
The adjustment is only necessary if the wick has been replaced.
When replacing the wick, make sure that the new wick is impregnated with oil.
● Move the centrifugal disk 1 (screw 2) according to requirement 1. ● Check requirement 2. If necessary, move centrifugal disk 1.
13 - 15