•FULL RANGE: This switch position transforms the P200 amplifier in to a high performance
4.LINE IN connectors are a set of dual RCA type plugs that accept an input signal from the subwoofer or main signal outputs from your home theater receiver or control center. Either one or both of the inputs can be used as required. The left and right input signals are summed together in the amplifier to provide it with a mono input signal.
5.LOW FREQUENCY EQ control adjusts the bass contour of the amplifier and subwoofer to allow the optimization of the subwoofer performance compensating for variations in room acoustics and installation locations. This control provides an
adjustment range of
6.TRIGGER INPUT is provided for remote control switching of the
7.A/C power line voltage selector is used to properly matching the line voltage of your wall outlet to the P200 amplifier. For the USA and Canada this switch is set to the
8.The power line cord socket is for the connection of the main power cord from your wall outlet to the amplifier. In the USA and Canada the amplifier is supplied with a standard IEC polarized power cord.
9.The power socket also contains the main power fuse for the P200 amplifier. Should the amplifier fail to operate unplug the amplifier from the wall outlet and remove the power cord from the rear of the amplifier. Remove the fuse cover located under the power cord socket by prying up on it with a small screwdriver and check the main power fuse. If the fuse is blown there is a spare fuse in the cover that can be used to replace the blown fuse. Replace the main power fuse with only the size and current specified on the rear of the amplifier per you’re A/C input voltage requirements.
SPECIFICATIONS
AMPLIFIER POWER | 200 WATTS CONTINUOUS LESS THEN .1% THD @ 4 OHMS, 350 WATTS PEAK |
| 150 WATTS CONTINUOUS LESS THEN .1% THD @ 8 OHMS, 215 WATTS PEAK |
CROSSOVER FREQUENCY | |
LFE FREQUENCY | |
RESPONSE |
|
FULL RANGE RESPONSE | |
INPUT SENSITIVITY | 150 mV FOR FULL OUTPUT |
LOW FREQUENCY EQ | |
DIMENSIONS | 17.75”W x 1.875”H x 11.75”D |
WEIGHT | 18 LBS |
Limited Warranty
Phase Technology warrants its loudspeakers to be free from defects in material and workmanship for a period of ten (10) years for speaker product and three (3) years for the electronic components to the original purchaser. Purchase must be made from an authorized Phase Technology dealer.
This warranty does not cover service or parts to repair damage caused by misuse, abuse, damage while in transit, alterations, unauthorized repairs, failure to follow instructions, fire, flood or any other cause beyond the reasonable control of Phase Technology. Defects in speaker cabinets or grilles must be brought to the attention of your dealer immediately after purchase. This warranty will be void if the products’ serial number has been altered or removed.
To obtain warranty service, defective product must be shipped in its original carton or equivalent together with original invoice or bill of sale, insured and prepaid to your authorized Phase Technology dealer or the factory when warranty service is requested.
If you choose to return the defective product to the factory you must first call us at (904)
Implied Warranties
Phase Technology will not pay for loss of time, inconvenience, loss of use, or property damage caused by your speaker product or its failure to work, or any other incidental or consequential damages. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation may not apply to you.
PHASE TECHNOLOGY CORPORATION |
|
6400 YOUNGERMAN CIRCLE |
|
JACKSONVILLE, FL 32244 |
|
| |
www.phasetech.com |
4
