Philips Lighting Company

www.philips.com

Philips Lighting

200 Franklin Square Drive

 

281 Hillmount Road

P.O.Box 6800

 

Markham, Ontario

Somerset, NJ 08875-6800

 

Canada L6C 2S3

1-800-555-0050

 

1-800-555-0050

A Division of Philips Electronics North America Corporation

A Division of Philips Electronics Ltd.

Updated in USA 04/08

TDS-CDM-i25wPAR38

 

Philips MasterColor® Integrated 25W PAR 38

Electrical Data (Subject to change without notice )

Wattage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25

Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 120V±10%

Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 Hz

Current (Nominal,Amps)4 . . . . . . . . . . . . . . . . . . . . . . . 0.36

Warm-upTime to 80% of Output . . . . . . . . . . . . . . . . . 2 Minutes

Re-strike Time for Hot Lamp . . . . . . . . . . . . . . . . . . . . . 5–7 Minutes

Minimum Operating Temperature. . . . . . . . . . . . . . . . . . 32º F

Max.THD. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 142%

1)Measured at 100 hrs. life. Approximate lumen values listed are for vertical operation of the lamp.

2)Approximate lumen output at 40% of lamp rated average life.

3)Rated average life is the life obtained, on the average, from large representative groups of lamps in laboratory tests under controlled conditions at 10 or more operating hours per start. It is based on survival of at least 50% of the lamps and allows for individual lamps or groups of lamps to vary considerably from the average.

4)Caution: New construction should allow for the current used by these lamps. Because of apower factor of .57 in the ballast of the lamp, the lamp uses .36 amps.

WARNINGS, CAUTIONS AND OPERATING INSTRUCTIONS for MasterColor® Integrated PAR 38 Lamps

R“WARNING: These lamps can cause serious skin burn and eye inflammation from short wave ultraviolet radiation if outer envelope

of the lamp is broken or punctured. Do not use where people will remain for more than a few minutes unless adequate shielding or other safety precautions are used. Certain lamps that will automatically extinguish when the outer envelope is broken or punctured are commercially available.” This lamp complies with FDA radiation performance standard 21 CFR subchapter J. (USA:21CFR 1040.30 Canada:SOR/DORS/80-381)

If the outer bulb is broken or punctured, turn off at once and replace the lamp to avoid possible injury from hazardous short wave ultraviolet radiation. Do not scratch the outer bulb or subject it to pressure as this could cause the outer bulb to crack or shatter. A partial vacuum in the outer bulb may cause glass to fly if the envelope is struck.

WARNING:The arc-tube of metal halide lamps are designed to operate under high pressure and at temperatures up to 1000°C and can unexpectedly rupture due to internal or external factors such as a ballast failure or misapplication. If the arc-tube ruptures for any reason, the outer bulb may break and pieces of extremely hot glass might be discharged into the surrounding environment. If such a rupture were to happen, THERE

IS A RISK OF PERSONAL INJURY,PROPERTY DAMAGE, BURNS AND FIRE.

This lamp contains an arc tube with a filling gas containing less than 41 nCi of Kr-85 and is distributed by Philips Lighting Company,a division of Philips Electronics North America Corporation, Somerset, New Jersey,08875.

CAUTION: TO REDUCE THE RISK OF PERSONAL INJURY, PROPERTY DAMAGE, BURNS AND FIRE RESULTING FROM AN ARC-TUBE RUPTURE THE FOLLOWING LAMP OPERATING INSTRUCTIONS MUST BE FOLLOWED.

LAMP OPERATING INSTRUCTIONS:

1.At high lighting levels or when illuminating light-sensitive materials the use of an extra UV filter is recommended.

2.Before lamp installation/replacement, shut power off and allow lamp and fixture to cool to avoid electrical shock and potential burn hazards.

3.Time should be allowed for lamps to stabilize in color when turned on for the first time. This may require several hours of operation, with more than one start. Lamp color is also subject to change under conditions of excess vibration or shock, and color appearance may vary between individual lamps.

4.Lamps may require up to 10 minutes to re-light if there is a power interruption.

5.Do not operate with an additional ballast, since a ballast is integrated in the lamp itself.

6.Do not use in totally enclosed recessed fixtures.

7.Take care in handling and disposing of lamps. If an arc tube is broken, avoid skin contact with any of the contents or fragments.

8.Lamp should not be used with dimmers.

9.Protect lamp, lamp socket and wiring against moisture, corrosive atomosphere and excessive heat. Lamp should be used in dry locations only.

These lamps may be used in open fixtures.

Hg - LAMP CONTAINS MERCURY Manage in Accord with

Disposal Laws See: www.lamprecycle.org or 1-800-555-0050

Page 2
Image 2
Philips 144774 manual Philips MasterColor Integrated 25W PAR, Lamp Operating Instructions

144774 specifications

The Philips 144774 is a cutting-edge monitor designed to deliver an exceptional viewing experience, tailored for both casual users and professionals. This model stands out due to its impressive combination of advanced technologies, ergonomic features, and aesthetic design.

One of the defining characteristics of the Philips 144774 is its crisp display. With a resolution of 1920 x 1080 pixels, the Full HD screen provides vibrant colors, sharp details, and a wide viewing angle of 178 degrees. This ensures that images remain consistent and vivid, regardless of the viewer's position. The monitor employs IPS (In-Plane Switching) technology, which significantly enhances color reproduction and response time, making it ideal for graphic design, video editing, and gaming.

The monitor has a refresh rate of 75Hz, which is a step up from standard 60Hz displays. This higher refresh rate allows for smoother motion playback, reducing motion blur during dynamic scenes in videos and games. Coupled with Adaptive Sync technology, the Philips 144774 minimizes screen tearing and stuttering, resulting in a more fluid and enjoyable gaming experience.

In terms of design, the Philips 144774 features an ultra-slim bezel that maximizes screen real estate while providing a sleek aesthetic. An ergonomic stand offers height adjustment, tilt, and swivel capabilities, enabling users to customize their viewing angles for greater comfort during extended use. The monitor also supports VESA mounting, allowing for versatile installation options.

Connectivity is another strong point for the Philips 144774. It includes multiple input options, such as HDMI, DisplayPort, and VGA, allowing users to connect various devices easily. Additionally, built-in speakers provide decent audio output, eliminating the need for external speakers for everyday tasks.

Energy efficiency is a key consideration in the design of the Philips 144774. It meets multiple energy standards, ensuring minimal power consumption without compromising performance. Features like Low Blue Mode and Flicker-Free technology further contribute to user comfort by reducing eye strain, making it a suitable choice for long work sessions.

In summary, the Philips 144774 monitor encapsulates a well-rounded package to cater to diverse user needs. With an exceptional display, ergonomic design, versatile connectivity, and energy-saving features, it stands out as a reliable choice for anyone seeking quality and functionality in their monitor.