4
EN

Preparing the remote control for

operation

The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging.You must install the batteries in the
remote control before use.
1.
1.Take the remote control and the enclosed bat-
teries (2 batteries).
2.
2.Open the remote control's battery compart-
ment and place the batteries in it as shown in
the picture and close the battery compartment.
The remote control is now ready to use.
Its range is approximately 7 metres.

Connecting the cable

1.
1.Insert the aerial cable plug into the AERIAL at
the back of the TV-Video Combi.
2.
2.Connect the mains cable to the wall socket.
3.
3.If the little red standby light (STANDBY ) at
the front panel of the set is not lit, please
switch on the set using the main power
switch.The power switch is located on the
left side panel of the set.
4.
4.Language setting picture will appear on the
screen.
You can find more details in chapter 'Preparation
for use'.

Connecting additional devices

You can connect additional devices such as
decoders, satellite receivers, camcorders, etc.to
the EXT1 socket.
1. Connecting the TV-Video Combi
WÄHLEN KL
→DEUTSCH
ENGLISH
ESPAÑOL
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
FORTSETZEN=MENU
I do not see a Language setting picture
* Check the cable connections.
The respective scart socket is usually marked
'
AV
'
or
'
TV
'
on the decoder or satellite receiver.

Specifications

Voltage:220-240V/50Hz
Power consumption (Standby):less than 5W
Rewind time:less than 260 seconds (cassette E-180)
Number of video heads :2
Recording/playback time:3 hours (SP)
(cassette E-180), 6 hours (LP) (cassette E-180)
Weight without packing in kg:11.5
Dimensions in cm (HxWxD):40.0x37.3x38.0
Power consumption : 52W

Supplied accessories

• Operating instructions
• Remote control and batteries
T6410EZ(EN).qx3 03.3.22 14:18 Page 4