Philips 26TA1000/93 setup guide Antenna TV, Basic Cable TV Connection

ANTENNA TV

A combination antenna receives normal broadcast channels (VHF 2–13 and UHF 14–69). Your connection is easy because there is only one 75 Ω (ohm) antenna jack on the side of your TV, and that’s where the antenna goes.

1If your antenna has a round cable (75 ohm) on the end, then you’re ready to connect it to the LCD TV. If your antenna has fl at, twin-lead wire (300 ohm), you fi rst need to attach the antenna wires to the screws on a 300- to 75-ohm adapter(not supplied).

2Connect the antenna (or adapter) to one end of the supplied L-Adapter as shown, and connect the other end of the L-Adapter to the TV jack on the side of the LCD TV.

3Plug the power cable into AC inlet on LCD TV set. Plug the power cable into an outlet and switch TV set on.

4Run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly.

Outdoor or Indoor Antenna (Combination VHF/UHF)

2

3

Twin-lead wire

to 300-75Ωadpter

or 1

Antenna with 75Ω cable

Wall outlet

HELPFUL HINT

•Remember, an antenna or cable TV signal must first be connected to your LCD TV.

•Please make sure that you have selected the TV mode with AV key on your remote control, before installing TV channels.

BASIC CABLE TV CONNECTION

Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decoder. In either case the connection is very simple. Follow the steps below to connect your cable signal to your new television.

Direct cable connections:

1Connect the Cable TV signal to one end of the supplied L-Adapter as shown, and connect the other end of the adapter to the TV jack on the LCD TV.

2Plug the power cable into AC inlet on LCD TV set. Plug the power cable into an outlet and switch TV set on.

2

1

3Run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly.

Rear Jack panel of Television

Wall outlet

The Cable TV singal from Cable Company 75Ω coaxial cable

HELPFUL HINT

•Remember, an antenna or cable TV signal must first be connected to your LCD TV.

•Please make sure that you have selected the TV mode with AV key on your remote control, before installing TV channels.

4