If you do not have a Cable Box, simply connect your Antenna or Cable TV signal directly to the ANT(enna) jack on the rear of the TV/VCR/DVD.
If you do have a Cable Box or Satellite Receiver, first connect the Cable TV or Satellite signal to the IN jack on the Cable Box or Satellite Receiver. Then, use an RF coaxial cable (not supplied) to connect the OUT jack of the Cable Box or Satellite Receiver to the ANT(enna) jack on the TV/VCR/DVD. To view any channel, set the TV/VCR/DVD to the output channel of the Cable Box or Satellite Receiver (channel 3 or 4). Then, select channels at the Cable Box or Satellite Receiver.
12nc: 8239 210 97091 Printed in China
27DVCR55
There are many ways to connect your new TV/VCR/DVD to your other equipment.This Quick-Use Guide shows the easiest, most common connections for the TV/VCR/DVD.
ANTENNA or
CABLE TV SIGNAL
2 | OUT | INCABLE BOX |
|
4 | | 3 |
ANT. | | |
L | | |
AUDIO OUT | | |
R | | |
COAXIAL | | |
| | RF COAXIAL |
| | CABLE |
ANT.ANT.
OR
1 Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.
2
3
4 When all connections are complete, plug the power cord of the TV/VCR/DVD into an active power outlet.
5 Press the STANDBY-ON 2 button on the TV/VCR/DVD or its remote to turn on the TV/VCR/DVD. The first time you turn on the TV/VCR/DVD, you should complete the TV/VCR/DVD setup. See the other side of this Quick-Use Guide for details.
