No dial tone.
Clean with a clean & dry cloth.
Handset not registered to base
Another call is already in
progress from another handset
or the base station.
TroubleshootingProblem
The handset is out of range,
( is not displayed).
The base station is not
properly connected to the mains
or the telephone line.
The handset has not been
registered to the base station
( is not displayed).
Move closer to the base
station and try again
Register the handset to the
base station (page 5)
Check the connections
Charge batteries (page 4)
Charging contacts are dirty.
Key tones are deactivated.
The charging unit is not properly
connected to the mains.
The base is being consulted
Check the connection
Contact your dealer.
Purchase new batteries
Register handset to base (page 5)
An error beep is heard from
the handset when trying to
make a call.
Retry when the current call is
finished.
The ringer is deactivated
The procedure has failed
The handset batteries are low
The maximum number of
handset has been reached.
Charge the batteries.
Wait until it is available
Activate it (page 10).
Try the procedure again
(page 5).
Un-register a handset (page 5)
Interference during call.
You are too far from the base.
The base station is too close to
electrical appliances,reinforced
concrete walls or metal door
frames
Get closer to the base station.
Move the base station to find a
better place (the higher the
better).
Check the connection between
charging unit and mains.
Activate them (page 10)
The batteries are low ( is
displayed).
Cause Solution
An error beep is heard
during a call.
The handset is out of range. Move closer to the base
There is no ringer.
The batteries remain low
although they have charged
for 12 hours.
When adding a handset to
the base station,a failure
message is displayed.
When the handset is placed
on the charging unit, no
beep is heard.
The charging unit is not properly
connected to the mains.
The batteries are defective or
too old.
Troubleshooting 11