Philips 8P6054C warranty Setting Your Remote to Work VCRS, Converters Search

SETTING YOUR REMOTE TO WORK VCRS, CONVERTERS - SEARCH

Your TV remote can be set to work your VCR or Cable Converter by what is called the

SEARCH method.

If the "REMOTE CODE" number method shown in the previous section did not set your remote to work your VCR or Converter, then follow the easy steps listed below.

Please read through steps 1-4 before beginning.

BEGIN

1Press the POWER button on the VCR or Converter to turn the unit ON.

2Stand at least six feet away from the front of the VCR or Converter.

Point the remote toward the unit. HOLD DOWN the SURF and the desired System (VCR or CBL-Converter) buttons at the same time. KEEP HOLDING BUTTONS DOWN.

3Watch the Channel Indicator on the unit.

Channel Numbers will SCAN UP when the unit has been identified. This may take up to two minutes.

4Release the SURF and System (VCR or CBL) buttons as soon as channel numbers start to scan up. The code has been identified and the remote is ready to operate with the VCR or Converter.

STOP

SMART HELP

Remember, a minute or two can seem very long, but

the code should be located within two minutes.

Don't let the VCR or Converter scan up more than five channels. The remote may pass up the right code and another two minute search cycle will have to be repeated.

If no channel change happens within two minutes, repeat steps 1-

4.Should a channel change still not occur, the remote will not work with the desired unit.

CABLE CONVERTER
1	06	07
		0809
	06
	0708
VCR	09
Don't let the VCR or Converter
scan up more than five channels		Six Feet
(in Search mode).
		(minimum)

3

REC ●		PLAY ▶		STATUS
CLEAR				LIGHT
REW		MENU
	−	M	+	FF
◀◀
				▶▶
				PAUSE II
MUTE		STOP	■	SURF
VOL				CH	2
ON/OFF		POS	SWAP	FREEZE		4
				SIZE
2 TUNER PIP		1	2	3
A◀ ◀ B

TV/VCR 4 5 6

ENTER

SLEEP 7 8 9

SMART0

POWER VCR CBL TV

M O D E

2 4

40