Philips AQ 6688 manual Tuning, Selecting & Storing Frequencies Presets

RADIO RECEPTION

TUNING

Direct Access tuning

The frequency of the station you wish to tune to must be known. You can find these frequencies in station tables or radio guides.

1In the radio mode, press ENTER.

ªThe current frequency in the display disappears.

2Use the Preset memory buttons to enter the digits of your desired frequency within a 5 second period.

3Press ENTER again to confirm your radio station.

ªThe display shows the selected frequency or the nearest frequency.

ªIf you have made an incorrect entry, Err will appear in the display.

Entry examples of bands and frequencies:

e.g.i	98.1 MHz, FM: Press 9,8,1 and ENTER
e.g.ii	603 KHz, AM (MW): Press 6,0,3 and ENTER

Manual tuning

•Press TUNING – or + briefly, once or as often as required until the right frequency is found. In this way, the frequency can be changed step by step.

Automatic tuning

1Press and hold down the TUNING – or + control until the display frequency starts to run.

2When a station of sufficient strength has been found, tuning will stop, or you can stop the automatic tuning by pressing the TUNING – or + control again.

3Repeat until you have found the desired station.

SELECTING & STORING FREQUENCIES: PRESETS

You can store the frequencies of 20 radio stations in the memory, 10 on each waveband. A stored frequency is only erased from the memory by storing another frequency in its place, or if you reset your unit.

1Select the waveband and tune to your desired station.

2Select and press one of the Preset memory buttons 0-9for more than two seconds to store your station.

ª PRESET and your selected number will appear in the display.

English

7