AZ1080/01 03/07/02 11:31 Page 13
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
Problem | Solution |
|
|
No sound | – Adjust the VOLUME |
|
|
No power | – Mains lead not securely connected. |
| Connect AC mains lead properly |
| – Batteries exhausted /incorrectly inserted. |
| Insert (fresh) batteries correctly |
|
|
Display does not function | – Electrostatic discharge |
properly/ No reaction to | Switch off and unplug the set. Reconnect after a few |
operation of any of the | seconds. |
controls |
|
|
|
Er indication | – No CD inserted, insert a CD |
| – CD badly scratched/ dirty. |
| Replace/ clean CD (see maintenance) |
| – |
| Use a finalized |
| – Laser lens steamed up. |
| Wait until lens has cleared/acclimatized |
|
|
CD playback does not work | – CD badly scratched/ dirty. Replace/ clean CD (see |
| maintenance) |
|
|
The CD skips tracks | – CD damaged or dirty. Replace or clean CD. |
| – Shuffle is active. Quit shuffle mode |
|
|
Poor cassette sound quality | – Dust and dirt on the heads, etc. |
| Clean deck parts, see maintenance. |
| – Use of incompatible cassette types (METAL or |
| CHROME). Only use NORMAL (IEC I) for recording |
|
|
Recording does not work | – Cassette tab(s) may be broken. Apply a piece of |
| adhesive tape over the missing tab space. |
13
