Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no cir- cumstances should you try to repair the set yourself, as this will inval- idate the guarantee.
No sound /power
–Volume not adjusted
• Adjust the VOLUME
–Power cord not securely connected
•Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
•Insert (fresh) batteries correctly
–Headphones connected to the set
• Disconnect headphones
–Disc contains
•Insert a suitable disc or press SEARCH ∞ or § once or more skip to an audio track, instead of the data files
The disc skips tracks
–Disc damaged or dirty
• Replace or clean disc
–Shuffle or program is active
• Switch off shuffle/program
Note:
For a disc with CD Audio tracks and MP3 files, only the CD Audio tracks will be played.
Sound skips during MP3 playback
–MP3 file made at compression level exceeding 320kbps
•Use a lower compression level to record CD tracks into MP3 format
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separat- ed into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging, dead batteries and old equipment.
Display does not function properly/No reaction to operation of any of the con- trols
–Electrostatic discharge
•Switch off and unplug the set. Reconnect after a few seconds
no indication
–No disc inserted
• Insert a suitable disc
–Disc badly scratched or dirty
• Replace/clean CD (See Maintenance)
–
• Use a finalized
–Laser lens steam up
• Wait until lens has cleared
Note:
Make sure the CD is not encoded with Copyright protection technologies, as some do not conform to the Compact Disc standard. .
–Disc damaged or dirty
• Replace or clean disc
Poor cassette sound quality
–Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
–Use of incompatible cassette types (METAL or
CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
–Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space
