TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee

English

PROBLEM

POSSIBLE CAUSE

• REMEDY

No sound/power

VOLUME is not adjusted

• Adjust the VOLUME

Headphones are connected

• Disconnect headphones

Mains lead not securely connected

• Connect the AC mains lead properly

Batteries exhausted/ incorrectly inserted

• Insert fresh batteries/ batteries correctly

CD playback sounds distorted at maximum level

Original CD pre-recorded at very high sound level

Reduce volume and/or deactivate any added sound features e.g. bass control

Display does not function properly/ No

reaction to operation of any of the controls

– Electrostatic discharge

Switch off set, disconnect the mains plug and reconnect after a few seconds

CD playback does not work

– CD is badly scratched or dirty.

Replace or clean the CD, see Maintenance.

– Laser lens steamed up

Wait until lens has acclimatized

The CD skips tracks

CD is damaged or dirty.

• Replace or clean the CD

SHUFFLE or a programme is active.

• Quit SHUFFLE/PROGRAM mode(s)

Poor cassette sound quality

– Dust and dirt on the heads, etc.

• Clean deck parts etc., see Maintenance

– Use of incompatible cassette types (METAL or CHROME)

• Only use NORMAL (IEC I) for recording

Recording does not work

– Cassette tab(s) may be broken out

Apply a piece of adhesive tape over the missing tab space

The type plate is located on the bottom of the set.

11

Page 11
Image 11
Philips AZ2000/01 manual Troubleshooting