XP SBC BC
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the warranty.
Problem | Remedy | |
|
|
|
No sound | – Check if the AC/DC adapter is fully inserted into the | |
| AC outlet and that its DC connector is properly inserted | |
| into the 12 Volt DC input connector located at the rear | |
| of the transmitter. | |
| – Check if the speaker’s on/off switch is in the on | |
| position. | |
| – Speaker batteries running low. | |
| Connect to the 9 Volt/1000 mA AC/DC adapter. | |
| (See Speaker power supply) | |
| – Check if the audio source is switched on and tuned to | |
| a channel with audio. | |
| – Volume not adjusted. Adjust the volume on the audio | |
| source/ speaker to a higher level. | |
| – Adjust the speaker’s tuning frequency.Turn the tuning | |
| wheel until the signal is at its clearest. | |
| – Make use of the HC8372 transmitter. Some | |
| transmitters already built into other equipment may not | |
| be compatible with the BC8310 speaker because of the | |
| advanced technologies used in the BC8310 speaker. | |
|
|
|
Distorted sound | – Adjust the speaker’s tuning frequency. | |
| Turn the tuning wheel until the signal is at its clearest. | |
| – Adjust the transmitter’s frequency. | |
| Select any of the 2 channels of the transmitter. | |
| – Speaker batteries running low. | |
| Connect to the 9 Volt/1000 mA AC/DC adapter. | |
| (See Speaker power supply) | |
| – Check the volume on audio source/ speaker is not set | |
| at too high a level. Reduce the volume. |
English
9