INSTALLATION
Power supply |
| Inserting batteries in the remote control |
|
|
|
|
|
|
English
1 Plug the power cord supplied into the MAINS connector on the CD recorder, then into a mains socket.
2 Press ON/OFF.
➜The recorder is now in Standby mode.
3 Press any key to activate the recorder.
Note:
-The CD recorder will automatically adjust to the local mains voltage.
-When the CD recorder is in the Standby mode, it is still consuming some power. If you wish to disconnect your recorder completely from the mains, press ON/OFF on the recorder front.
1 Open the battery compartment cover.
2 Insert 2 batteries (“AA”,
3 Replace the cover.
Note: We recommend you use 2 batteries of the same type and condition.
Batteries contain chemical substances, so they should be disposed of properly.
Setup recommendations
-Place the CD recorder on a solid, vibration free surface.
-Do not place the CD recorder near a source of heat or in direct sunlight.
-Do not use the CD recorder under extremely damp conditions.
-If the CD recorder is placed in a cabinet, make sure that a 2.5 cm space remains free on all sides of the CD recorder/player for proper ventilation.
13
