Philips CEM200 user manual Mount in the dashboard, Tip

Tip

‡The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit.

Mount in the dashboard

1If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery. ‡ If you disconnect the car battery in

a car that has an on-board drive or navigation computer, the computer may lose its memory.

‡ If the car battery is not disconnected, to avoid short-circuit, ensure that bare wires do not touch each other.

2Remove the two screws on the top of the unit.

3Remove the mounting sleeve with the supplied disassembly tools.

4Ensure that car dashboard opening is within these measurements:

	5mm
1
83	mm
	53mm

5Install the sleeve into the dashboard and

EHQGWKHWDEVRXWZDUGWRÀ[WKHVOHHYH

Note

‡6NLSWKLVVWHSLIWKHXQLWLVQRWÀ[HGE\VOHHYH but by supplied screws.

12EN