Philips DVD-703 Preparation, General Notes, Connecting to a TV, Connecting to Optional Equipment

Preparation

En gli sh

General Notes

¶Depending on your TV and other equipment you wish to connect, there are various ways you could connect the player. Use only one of the connections described below.

¶Please refer to the manuals of your TV,VCR, Stereo System or other devices as necessary to make the best connections.

¶For better sound reproduction, connect the player’s audio out jacks to the audio in jacks of your amplifier, receiver, stereo or audio/video equipment. See ‘Connecting to optional equipment’.

Caution:

–Make sure the DVD player is connected directly to the TV. Set the TV to the correct video input channel.

–Do not connect the player’s audio out jack to the phono in jack of your audio system.

–Do not connect your DVD player to the TV via your VCR.The DVD image could be distorted by the copy protection system.

TV

A X Z Y

DIGITAL AUDIO OUT
PCM-MPEG2-Dolby Digital-DTS
	R	L	(CVBS)	PR/CR	PB/CB	Y	S-VIDEO
COAXIAL	AUDIO OUT				VIDEO OUT

Connecting to a TV

¶Make one of the following connections, depending on the capabilities of your existing equipment.

Component Video (PR/CR PB/CB Y) connection

1Connect the PR/CR PB/CB Y video out jacks on the DVD player to the corresponding in jacks on the TV using an optional PR/CR PB/CB Y cable (Z).

2Connect the Left and Right audio out jacks of the DVD player to the audio left/right in jacks on the TV (A).

S-Video (Y/C) connection

1Connect the S-Video video out jack on the DVD player to the S-Video in jack on the TV using an optional S-Video cable (Y).

2Connect the Left and Right audio out jacks of the DVD player to the audio left/right in jacks on the TV (A).

CVBS connection

1Connect the CVBS video out jack on the DVD player to the video in jack on the TV using the video cable supplied

(X).

2Connect the Left and Right audio out jacks to the audio left/right in jacks on the TV (A).

Connecting to Optional

Equipment

Connecting to an amplifier equipped with two channel analog stereo or Dolby Surround

1Connect the Left and Right audio out jacks of the DVD player to the audio left and right in jacks on your amplifier, receiver or stereo system, using the supplied audio cable

(A).

Connecting to an amplifier equipped with two channel digital stereo (PCM) or to an Audio/Video receiver equipped with a multi-channel decoder (Dolby Digital™, MPEG 2 or DTS)

1Connect the player’s coaxial digital audio out jack to the corresponding coaxial digital audio in on your amplifier. Use an optional digital audio cable (F).

2You will need to activate the player’s digital output (see ‘Personal Preferences’).

Digital Multi-channel sound

The digital multi-channel connection provides the best sound quality. For this you need a multi-channel Audio/ Video receiver that supports one or more of the audio formats supported by your DVD player (MPEG 2, Dolby Digital™ or DTS). Check the receiver manual and the logos on the front of the receiver.

8PREPARATION