18 PREPARATION

Connecting to an amplifier equipped with Dolby

Surround™

Dolby Surround sound
1Connect the player to the TV,then connect the player’s audio Left and
Right out jacks to the corresponding in jacks on the Dolby Surround™
Audio/Video receiver,using the audio/video cable supplied
(C)
.
If your amplifier is equipped with a Dolby Digital™ decoder,
●Connect the player as described in ‘Connecting to an A/V receiver with
multi-channel decoder’.
If your TV is equipped with a Dolby Surround™ decoder,
●Connect
the player to the TV as described in ‘Connecting to a TV’.
Connecting the power cord
1Plug the female end of the supplied power cord into the Mains (AC) jack
on the rear of the player.
2Connect the other end of the cord to an AC outlet.
Note:
When the player is in the “STANDBY”mode, it is still consuming some
power.If you wish to disconnect your player completely from the power, press
POWER ON/OFF
Caution:Only qualified service personnel should remove the
cover or attempt to service this device.
Remote control battery installation

Loading the batteries

1Open the battery compartment cover.
2Insert batteries as indicated inside the battery compartment.
3Close the cover.
Caution:Do not mix old and new batteries. Never mix
different types of batteries (standard,alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the
video signal of your TV.This setting only affects the television’s on-screen
display that shows the stop and setup modes.You may select either
NTSC or PAL.To change the DVD player setting to PAL or NTSC,
follow the steps below.
1Press the POWER ON/OFF button on the front panel of the DVD
player to turn OFFthe DVD player.
2Press and hold 9and Ton the front of the DVD player.While
holding 9and T, press POWERON/OFF.
3After PAL or NTSC appears on the display panel of the DVD player,
release 9and Tat the same time.The PAL or NTSC that appears on
the display panel indicates the current setting.
4To change the setting,press Twithin three seconds.The new setting
(PAL or NTSC) will appear on the display panel.
+
-
+
-
L
R
CVBS
VIDEO OUT
COAXIAL AUDIO
YS-VIDEO
OPTICAL
1
DIGITAL AUDIO OUT
PCM/MPEG2/AC3/DTS
1
22
C
B
C
R
MAINS
TV
CB
A