Software upgrade
Preparation to upgrade software
1)Start the CD Burning software and create a new CD project (Data Disc) with the following setting:
Label: DVP3XXX (No need the label name)
File Name: DVPXXXX_XX.BIN
Power on the set and open the tray, then press <option> to check the File Name.
Note: It is required capital letter for the File System name.
2) Burn the data onto a blank CDR
A. Procedure for software upgrade:
1)Power on the set and insert the prepared Upgrade CDR.
2)The set will starts reading disc & response with the following display TV screen:
Upgrade File DETECTED Upgrade?
Press Play TO START.
3)Press <OK> button to confirm, then screen will display :
Files coping…
UPGRADING…
4)The upgraded tray will automatically open when files coping complete, then take out the disc.
5)About 1 minute later, the trace will automatically close when upgrading complete.
B. Read out the software versions to confirm upgrading
1)Power on the set and press <Setup> button on the remote control.
2)Press <Next><Next><Prev><Prev> button.
The software version and other information are display on the TV screen as follows:
Version XX.XX.XX.XX (Main version)
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX (software version of servo) RIS XX.XX.XX.XX
DSP XX.XX.XX.XX Region Code X
Caution: The set must not be power off during upgrading, Otherwise the Main board will be damaged entirely.
