Page 4 of 5
SECTION 7: PRECAUTIONS FOR SAFE HANDLING AND USE (Cont'd)
Safe Handling: Read and Follow the installation/operating instructions listed below to help reduce risk of personal injury and property damage and help prevent early lamp failure:
1)Before lamp installation/replacement, shut power off & allow lamp & fixture to cool to avoid
electrical shock & potential burn hazards.
2)Protect lamp from abrasions & scratches. Do not install or use cracked or broken lamp. If lamp cracks or breaks in use, disconnect power supply immediately, allow system to cool & remove lamp.
3)Do not touch lamp with bare hands. If touched with hands, clean lamp with denatured alcohol and wipe with a
4)Replace lamp at or before the end of rated life. Allowing lamp to operate until it fails is not recommended and may increase the risk of inner arc tube rupture.
5)Use within voltage limits recommended by ballast manufacturer. Do not operate lamp at higher than specified power.
6)The permissible maximum operating temperatures (e.g., the pinch temperatures, the tempera-
ture of the bulb wall) as indicated on the product leaflet may not be exceeded.
7)Lamp should be operated within 10 degrees of the horizontal position to insure maximum operating efficiency.
SECTION 8: SPECIAL PROTECTION DATA
WARNING: THIS LAMP EMITS SHORTWAVE ULTRAVIOLET RADIATION. USE ONLY IN EQUIPMENT DESIGNED TO REDUCE RISK OF PERSONAL INJURY AND PROPERTY DAMAGE. DO NOT LOOK AT OPERATING LAMP WITHOUT PROTECTIVE FIXTURE AND/OR PROTECTIVE GOGGLES. DO NOT USE LAMP IF ULTRAVIOLET FILTER GLASS IS MISSING OR DAMAGED.
A division of | 200 Franklin Square Drive |
Philips Electronics North America Corporation | P.O. Box 6800 |
| Somerset, NJ |
| Tel: 732.563.3000 |
