Philips LPC2138 dimensions Power Supply, Jumper & Connector Descriptions

Power Supply

The target board is powered from the PC USB port, through which winIDEA (IDE) running on a PC, connects to the on-board integrated debugger. Connection is made using a standard USB cable. Battery power supply for RTC can be optionally connected to J11 (see J11 description for more details).

Jumper & Connector Descriptions

•J7: Trace Port Enable: J7 is set to enable pins P1.25:16 to operate as ETM Trace port after reset. Default not set.

•J8: Debug Port Enable: J8 is set to enable pins P1.31:26 to operate as a JTAG Debug port after reset. Default is set.

•J9: Debug Mode: J9 selects whether iSYSTEM on-board integrated USB-JTAG debugger is used or an external debug tool. Default set in position 1-2.*

•J10: RTC Power Supply Selector: J10 connects Vbat pin of LPC2138 to the main 3.3V.

•J11: RTC Power supply: PCB terminal providing connection for battery. When battery power supply applied to J11 is used, J10 must be open.

•J12: Manufacturing purpose connections

•J13: Analog Output: J13 is analog output from OP amplifier, which connects to output of the DA converter.

•J14: Serial Port (UART 0): three pins connected to UART0. See connectors for more details.

•J15: User LEDs Enable: enables the LED driver connecting the on-board LEDs to GPIO P0.8 – P0.11.

•J16: User Buttons Enable: enables buttons driver connecting the on-board buttons to GPIO P0.12 – P0.15. Pushing the button generates a low signal. If J16 is set, the CPU will not start in Boot-loader mode (see J25 description).

•J17: LCD Enable Signal: connects GPIO P0.21 to the LCD enable pin.

•J18: LCD R/W Signal: connects GPIO P0.22 to the LCD R/W pin.

•J19: Analog Output Enable: connects DA converter output (GPIO P0.25) to the OP amplifier.

•J20: Analog Input Enable: connects the TRIM potentiometer to the analog input AD0.0 (GPIO P0.27).

•J21: 16 Pin LCD Connector: see connectors

•J22: LCD LED Backlight Enable: J22 is set to turn on LCD backlight.

•J25: Startup mode (populated on the bottom side of the target board): J25 connects either a pull-up (USER mode) or a pull-down (BOOT-loader mode) to P0.14. Default set in position USER (User mode). J16 must be removed when setting J25 in position BOOT, otherwise J25 setting is not effective.

*Jumper pin 1 is marked with a white square on the ITLPC2138 PCB. If pin 1 cannot be located directly from the ITLPC2138, please use Figure 2 for assistance.

Note: Don’t change jumper settings while the target board is supplied with power!

© iSYSTEM, December 2005 6/16