Philips MC-110 manual RU240- page, English

RU240- page 3

If you know the brand of your equipment, look at the code list at the back of this booklet, and find the first 5-digit code for your equipment.

1Press and hold s and y at the same time until the green LED lights up. (Release the keys, the green LED should stay on)

2Enter the 5-digit code using the numbers that correspond to the function keys (see diagram). The green LED blinks twice.

That's it! Now, press a few keys on the remote to check that the equipment responds correctly. If it doesn't, try again using the next code in the list. In the rare instance that none of the codes work, follow the instructions in the next section.

Tip: Make a note of the code inside the battery case, and in the back of this booklet in case you ever need to setup again.

If you don't know the brand of your equipment or if you can not find it in the codelist, setup still won't take long. Philips' patented Handsfree autosearch tests all the codes one after another and finds the right one for you! The search time averages about 90 seconds. (Maximum search time is 5 minutes for TV.)

Make sure the TV is switched on. You will know when the correct code has been found because the equipment will switch off.

1Press and hold s and y at the same time until the green LED lights up.

2Press y to start the search. Each time the green LED blinks, another code is sent. When the right code is found, the equipment switches off.

3Immediately press y to stop the search.

If you missed the correct code because the search went too far, switch the equipment back on, the press -P(down) to send the previous code again. Press -P(down) repeatedly until the equipment switches off again.

4Once you've found the correct code, press y to lock it in memory. The green LED blinks twice.

That's it! Now, switch the equipment manually on again, then press a few keys on the remote to check that the equipment responds correctly. In the rare instance that it doesn't, try again from step 1 to find a better code.

Note that code! To save time if you ever need to setup again, make a note of the correct code inside the battery case and in the back of this booklet. In case you have forgotten to note the code you can still 'read out' the code from the remote. Here's how:

1Press and release s and y at the same time; the green LED lights up.

2Press s . The green LED goes out.

3 Press +P and count the number of times the green LED blinks. This is the first digit of the 5-digit code. (No blinks means the digit is zero.)

Press -Pand count the number of blinks for the second digit.

3

English