
SAFETY | CONTROLS |
Know these ssaaffeettyy symbols
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This “bolt of lightning” indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering.
The “exclamation point” calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.
CANADA
English: This digital apparatus does not exceed the Class B limits for noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.
Français: Cet appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de Classe B prescrites
1
7
5
8
9
2
1
3
4
| 1SLEEP/ RADIO ON | 8ALARM 2 - BUZZ and also PRESET 2 |
| – displays/ adjusts/ switches off sleep time | – selects buzzer mode on or off for alarm 2 |
1 | – switches on radio; displays radio frequency | – stores and selects PRESET station 2 |
3SNOOZE/ BRIGHTNESS CONTROL | 9ALARM 1 - RADIO and also PRESET 1 | |
| – switches off the alarm for 9 minutes period | – selects radio mode on or off for alarm 1 |
| – changes the brightness of the display illumination | – stores and selects PRESET station 1 |
2 | 3ALARM RESET/ RADIO OFF | 0VOLUME |
– stops the active alarm for 24 hours | – adjusts the sound level | |
| – stops radio /sleep function | !SET control |
| 4BAND | – sets the times for •ALARM 1, •ALARM 2, •TIME |
3 | – selects FM/AM waveband | and to RUN on clock time |
5TIME SET/ TUNING: 1 MIN and HR 2 | @Power cord | |
4 | – adjusts the hours (HR 2) and minutes (1 MIN) | – for AC power supply and improve FM reception |
for clock/ alarm times |
| |
5 | – tunes (1 , 2) to radio stations | The type plate is located on the bottom of the set. |
6PRESET 3, 4 and 5 |
| |
|
| |
6 | – stores and selects preset stations |
|
7Display |
| |
| – shows the clock/ alarm times and status of the set |
|
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
CAUTION: To prevent electric shock, match wide
blade of plug to wide slot, and fully insert.
dans le Régelement sur le Brouillage Radioélectrique édicté par le Ministère des Communications du Canada.
0
5 | Environmental information |
|
All unnecessary packaging material has been omitted to make the packaging easy to separate into two materials: paper (box and paper pulp), polyethylene (bags, protective foam).
Your set consists of materials, which can be recycled if disassembled by a specialized company. Please observe the local regulations to dispose of packing materials, dead batteries and old equipment.
IMPORTANT SAFETY INSTRUCTIONS – Read before operating equipment | INSTALLATION | BASIC FEATURES |
PHILIPS CONSUMER ELECTRONICS COMPANY
A Division of Philips Electronics North America Corporation
Knoxville, Tennessee
Meet PHILIPS at the Internet http://www.philipsusa.com
MG-C200
MG-C205
This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of.
1. | Read these instructions – All the safety and operating |
| instructions should be read before the appliance is |
| operated. |
2. | Keep these instructions – The safety and operating |
| instructions should be retained for future reference |
3. | Heed all warnings – All warnings on the appliance and |
| in the operating instructions should be adhered to. |
4. | Follow all instructions – All operating and use |
| instructions should be followed |
5. | Do not use this apparatus near water – for example, |
| near a bathtub, washbowl, kitchen sink, laundry tub, in a |
| wet basement or near a swimming pool, etc. |
6. | Clean only with a damp cloth. The appliance should be |
| cleaned only as recommended by the manufacturer |
7. | Install in accordance with the manufacturers |
| instructions. Do not block any of the ventilation |
| openings. For example, the appliance should not be situated |
| on a bed, sofa, rug, or similar surface or placed in a |
| installation, such as a bookcase or cabinet that may impede |
| the flow of air through the ventilation openings. |
8. | Do not install near any heat sources such as radiators, |
| heat registers, stoves, or other apparatus (including |
9.Do not defeat the
safety purpose of the polarized or
plug has two blades with one wider than the other. A grounding type
plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10.Protect the power cord from being walked on or pinched particulary at plugs, convenience receptacles, and the point where they exit from the apparatus
11.Only use attachments/accessories specified by the manufacturer
12.Use only with a cart, stand, tripod, bracket,
or table specified by the manufacturer, or sold
with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury from
13.Unplug this apparatus during lightning storms or when unused for long periods of time
14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
2 |
! |
@ |
POWER SUPPLY AND DEMO MODE
1.Check if the power voltage, shown on the type plate on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service centre.
2.Connect the power plug to the wall outlet. The power supply is now switched on and the display will show the PHILIPS demo mode.
ªPH..IL ..IPS scrolls across the display continuously.
•Turn the SET control to SET TIME to exit the demo mode.
3. To disconnect the set completely from the power supply, withdraw the power plug from the wall outlet.
POWER BACK-UP
The power
If power supply returns after 3 minutes and the display shows:
•clock time blinking – indicates you need to
•PHILIPS demo mode – indicates you need to
ILLUMINATION BRIGHTNESS
1.Check if the SET control is turned to CLOCK position and the radio is switched off.
2.Press SNOOZE/ BRIGHTNESS CONTROL once or more.
–The brightness of the display will change in this sequence:
BRIGHT yMEDIUM yLOW yBRIGHT...
Note:
when an alarm or the SLEEP function is active, brightness cannot be adjusted.
RESET
Should the display and electronic functions of your set receive interference e.g. static electricity from carpets, thunderstorms, etc. RESET allows you to clear all previous settings and start up again.
•Use a ballpoint pen to press the RESET hole found on the bottom of the set.
Printed in Hong Kong
amplifiers) that produce heat |
moisture, does not operate normally, or has been dropped
EL
ªBoth the model number and production number are on the bottom of the set.