Philips MZ5 warranty General information Power supply, Connections, Speaker connections

XP MZ5/37 15-04-2002 13:14 Pagina 10

General information Power supply Connections

English

Speaker connections

The speaker terminals are click-fit connectors. Use them as shown below.

R	L	R
AUX in
8 Ω	speakers

LEFT	LEFT
–	+

RIGHT	RIGHT
–	+

Safety information

•Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating.

•The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

•Connect the marked red wire to the red terminal and the unmarked wire the black terminal.

•When headphones are inserted into the headphone jack the speakers are disconnected.

AUX IN

You can connect the audio left and right OUT terminals of another sound system, e.g. CDR, cassette recorder to the corresponding left and right AUX IN terminals at the rear of the set.

•Use the MZ-5 sound controls to adjust the sound of the other system.

Power supply	• For playback of a connected CD-R(W), select
1 Check if the power voltage, as shown on the	the CD-R(W) source.
type plate located on the bottom of the
set, corresponds to your local power voltage. If it
does not, consult your dealer or service center.
2 If your set is equipped with a voltage selector on
the bottom of the set, adjust the selector so that
it matches with the local power voltage.
3 Connect the power plug to the wall outlet and
the set is now ready for use.
➜ The clock display ··· : ··· flashes.
4 To disconnect the set from the power
completely, remove the plug from the wall outlet.
Power-saving automatic standby
As a power-saving feature, the unit automatically
switches to standby if:
– 15 minutes after a CD has reached the end
and no control is operated.
– after more than 24 hours no controls are
operated.

10