Philips manual Preparing for use, Using the appliance, Corded trimming QT4060 only

8ENGLISH

-Do not recharge the appliance between trimming sessions.

-Discharge the battery completely twice a year by letting the motor run until it stops.Then fully recharge the battery.

-If the appliance has not been used for a long period of time, it must be fully recharged.

Preparing for use

Always comb your beard or moustache with a fine comb before you start trimming.

Using the appliance

Corded trimming (QT4060 only)

Do not run the appliance from the mains when the battery is fully charged.

BIf the battery is low, you can also use the appliance from the mains:

1Switch the trimmer off, connect it to the mains and wait a few seconds before switching it on.

2If the battery is completely empty, wait a few minutes before switching the appliance on.

Absorbing cut hairs

The suction system is activated automatically as soon as you switch the appliance on. It absorbs cut hairs during every kind of use, i.e. trimming with and without comb attachment and contouring.The flexible hair guide follows the contours of the face and directs cut hairs towards the nozzle of the vacuum mechanism.

We advise you to empty the hair-collection chamber after each trimming session. When trimming long, dense beards it may also be necessary to empty the hair-collection chamber during the trimming session in order to maintain optimal suction performance (also see chapter 'Cleaning', section 'Hair-collection chamber').