SBC MC8650_ENGLISH_6
SBC MC8650_ENGLISH_7
6ENGLISH
ENGLISH 7
PHILIPS | |
SBC MC8 | 652 |
POWER | |
VOLUME
Operation
1 Switch microphone to ON, and the receiver to CH A or CH B.
>Make sure the channel selection on the microphone matches with the receiver.
>The power indicator lights up. Indicator: starts blinking if battery level is low. You should then replace the battery.
2 Adjust the volume of your HiFi or karaoke system to the desired level.
Problem | Remedy |
Distortion | Microphone battery running low. Replace with a new battery |
|
|
| Interference from other Radio service, select the other Channel |
|
|
| Ensure the audio source's volume is not set at a too high level. Reduce the |
| volume |
|
|
| Do not place the receiver or the microphone near fluorescent lamps |
|
|
| Adjust the microphone input level (if available) as well the volume on your |
| HiFi or karaoke system |
|
|
| Radio equipment for wireless audio applications is not protected against disturbance |
Troubleshooting
| If a fault occurs, first check the points listed below before taking the set for repair. |
| If you are unable to remedy a problem by following these hints, consult your |
| dealer or service centre. |
| WARNING: Under no circumstances should you try to repair the set |
| yourself, as this would invalidate the warranty. |
Problem | Remedy |
|
|
No sound | Check if the DC connector is properly connected to the receiver and the |
| mains socket |
|
|
| Check if the microphone is in the ON position, and that the microphone |
| Channel selection matches the receiver |
|
|
| Check if the audio cable is connected to the microphone input of the HiFi or |
| karaoke system. Also check if the appropriate audio source has been selected |
|
|
| Microphone battery running low. Replace with a new battery |
|
|
| Adjust the microphone input level (if available) as well the volume on your |
| HiFi or karaoke system |
|
|
from other radio services. |
|
|
| |
Specifications |
|
|
| |
System: Radio Frequency |
|
|
| |
Carrier Frequency: Channel A – 863.3 MHz |
|
| ||
| Channel B – 863.7 MHz |
|
| |
Modulation: Frequency Modulation (FM) |
|
| ||
Radiated Output Power: < 10m Watt |
|
| ||
Effective Transmission Range: 30 metres |
| |||
Microphone |
|
|
|
|
Power supply: 9 Volt Battery |
|
|
| |
Microphone receiver power supply: 12Volt/200mA DC |
| |||
Output Level: < 5mV |
|
|
| |
Frequency Range: 100 – 10,000Hz |
|
| ||
Sensitivity: |
|
|
| |
Signal/Noise ratio: > 60dB |
|
|
| |
Distortion: < 0.5% THD |
|
|
| |
European Regulations |
|
|
| |
This product has been designed, tested and manufactured according the | ||||
European R&TTE Directive 1999/5/EC. |
|
| ||
Following this Directive, this product can be brought into service in the | ||||
following states: |
|
|
|
|
R&TTE Directive 1999/5/EC |
|
|
| |
B | DK | E | GR | F |
IRL | I | L | NL | A |
P | SU | S | UK | N |
D | CH |
|
|
|
