Philips SC466 warranty Using batteries, Technical specifications, Problem solving

6ENGLISH

ENGLISH 7

3

VITY	+
OPEN

Power supply:

Power supply:

Using batteries

Operating the Baby unit cordlessly

1Charge the batteries for at least 14 hours

Remove the power adapter from the Baby unit power socket

Use the Baby unit cordlessly for up to 10 hours

2> if the power light flashes red, recharge the batteries

Replacing the battery packs

1Open the Baby unit’s battery compartment cover.

2

Open the Parent unit’s batterycompartment cover .

3 Disconnect the old battery pack from the power plug and remove.

Carefully connect the new battery pack to the power plug and place

4inside the battery compartment.

Close battery compartment cover.

Batteries

Dispose of used batteries in an environmentally friendly manner. Do not mix old and new batteries, or different types of batteries.

Technical specifications

•Battery pack; rechargeable NiMH for Parent and Baby unit (included);

•AC power adapter 230V AC, 50 Hz (two included): - Output voltage 9V DC, 200mA.

•Only use the AC power adapter included

	Problem solving
Problem	Possible cause	Solution
Power light does not	Parent unit: unit is not turned on.	Turn VOLUME ON/OFF control
light.		downwards.
	Batteries are low.	Recharge batteries.
	Baby unit: unit is not turned on.	Push power button.
	Power adapter is not plugged in or	Plug in power adapter or recharge
	batteries are low.	batteries.
High pitched noise.	Units are too close together.	Move parent unit away from baby
		unit. Turn VOLUME ON/OFF
		control on parent unit upwards.
Batteries	Battery life is at an end.	Connect charging base to mains
do not charge.		power. Replace battery pack.
No sound.	Volume on parent unit is set too	Turn VOLUME ON/OFF control
	low.	downwards.
Power light flashing.	Batteries are low
		Recharge the battery packs
Interference or poor	Mobile or cordless phones too close	Move phones away from the units.
reception.	to the baby monitor.
Pick-up from another	Both systems are operating on the	Switch channels.
baby monitor.	same frequency.
System check light	Units are out of range or there is	Move units closer together to
flashing (red) /	interference from another FM	restore the link. Remove the other
System check alarm.	source.	FM source.

Operating range:	• up to 250 metres in ideal conditions (walls, floors, etc. can limit this distance.)
Operating temperature:	•	-10°C to 40°C
Digital Pilot tone:	•	Continuous communication link (hidden signal helps reduce interference and ensures a
		continuous link between both units so you only hear your baby’s sounds).
Transmission frequencies:		SBC SC466/00:	from 40.695 to 40.675 MHz

I