Philips SCF260/33 manual Always check feed temperature before feeding, Approximate Warming Times

•To avoid possible scalding, do not place hands over the lid flap or open the lid flap during the warming cycle.

•When warming an 11oz/330ml bottle or an 8oz/236ml Tempo, the lid flap will lift to accommodate the larger size. This will cause a small amount of steam to rise from the warmer.

•To avoid possible scalding, take care when opening the lid after a completed cycle as there may be some residual steam.

•When in use, the warmer contains hot water. Be careful to avoid spilling any water on yourself when removing contents from the warmer.

•Use the lifter to remove small bottles, VIA Cups and small food jars after the warming cycle is complete.

•Always use a cloth when removing bottles, cups and jars from the warmer.

•Always check feed temperature before feeding.

•For microbiological and hygienic reasons, once heated, milk and food should not be reheated again.

•Never immerse the warmer or power cord in water.

•Close supervision is necessary when this product is used near children or persons with disabilities.

•Failure to follow de-scaling instructions may cause irreparable damage.

•Before serving, unplug cord from wall outlet. Do not leave cord within child’s reach.

•HOUSEHOLD USE ONLY.

SAVE THESE INSTRUCTIONS

Interactive Electronic Display Guide

Water Amount Required

/		1oz / 30ml
		5oz / 150ml
/	/	5oz / 150ml

Note: If you find that thicker foods are not warm enough at the end of the warming cycle, consult the Troubleshooting Guide.

Note: Warming food jars from frozen is NOT recommended. However, you can warm frozen food in VIA Cups within the warmer.

Approximate Warming Times

Milk 4oz/120ml from room temperature	2 mins
Milk 4oz/120ml from chilled	3 mins
Milk 9oz/265ml from room temperature	3 mins
Milk 9oz/265ml from chilled	4.5 mins
Food 8oz/240ml from room temperature	5 mins
Food 8oz/240ml from chilled	7 mins

Care of your Digital Bottle and Baby Food Warmer

Always unplug the warmer and allow it to cool before cleaning. Wipe the inside and outside of the warmer with a damp cloth. DO NOT USE AN ABRASIVE CLEANER. Using cool pre-boiled or filtered water in your warmer may reduce limescale build-up. When the warmer needs de-scaling, the mode and starting temperature symbols will flash on the electronic display. To

Milk Mode

(in ANY container)

Baby Food Mode (in ANY container)

Freezer Temperature Mode (select when warming from frozen)

Fridge Temperature Mode (select when warming from chilled)

Room Temperature Mode (select when warming from room temperature)

Power/Mode Selection Button – Hold button for 3 seconds to switch the warmer on/off. Press repeatedly to select milk or baby food and starting temperature.

Volume Selection/Start Button – Press repeatedly to select the volume of milk or food. Once desired selections are made, hold button for 3 seconds to start warming cycle.

	150	5		Volume Display –
ml	120	4	fl.oz
	90	3		Displays the selected amount of liquid
	60	2		or food in both oz and ml.
	30	1

ensure maximum effectiveness, you should de-scale your warmer every time it is required. To acknowledge the de-scale warning, press and hold the Power/Mode Selection or Volume Selection/Start Button for 3 seconds. If you do not wish to de-scale, please be aware that the unit will not remind you to de-scale on your next use, but will instead begin re-counting cycles until the next de-scaling is needed.

IMPORTANT! DE-SCALING

Under no circumstances should anything other than citric acid or vinegar be used as it may cause irreparable damage. Avoid contact with eyes as this may cause irritation. Keep out of the reach of children.

EITHER:

Mix one pack of citric acid (10g) with 7oz/210ml of water. Pour solution into the empty warmer. DO NOT place a bottle, jar or cup into the warmer when de-scaling. Close the lid of the warmer and set the warmer to run with 11oz/325ml of milk from frozen. After the warming cycle has ended, leave the solution to cool for 30 minutes before emptying the warmer and rinsing with tap water. Wipe the inside and outside of the warmer with a damp cloth only. OR:

Note: While pressing the Power/Mode Selection or Volume Selection/Start Button, please hold the warmer base to prevent the warmer from slipping.

Pour 3.5oz/100ml of vinegar mixed with 7oz/210ml of cold water into the warmer. Allow liquid to stand in the unit until any limescale has dissolved. DO NOT place a bottle, jar or cup into the warmer when de-scaling. DO NOT start the warming cycle. Empty the unit and rinse thoroughly. Wipe the inside and outside of the warmer with a damp cloth only.

4 5